[media] v4l2-subdev: reorder the v4l2_subdev_video_ops comments
The comments for struct v4l2_subdev_video_ops are out of the order as the parameter would appear at struct. This is not a problem for DocBook, but humans find harder to mentally reorder ;) So, put them at the right order. That makes easier to check what's missing, and to put the comments in the right place. Signed-off-by: Mauro Carvalho Chehab <mchehab@osg.samsung.com> Acked-by: Jonathan Corbet <corbet@lwn.net>
This commit is contained in:
Родитель
91963aae9a
Коммит
b84aeb03a8
|
@ -309,6 +309,15 @@ struct v4l2_mbus_frame_desc {
|
|||
/**
|
||||
* struct v4l2_subdev_video_ops - Callbacks used when v4l device was opened
|
||||
* in video mode.
|
||||
*
|
||||
* @s_routing: see s_routing in audio_ops, except this version is for video
|
||||
* devices.
|
||||
*
|
||||
* @s_crystal_freq: sets the frequency of the crystal used to generate the
|
||||
* clocks in Hz. An extra flags field allows device specific configuration
|
||||
* regarding clock frequency dividers, etc. If not used, then set flags
|
||||
* to 0. If the frequency is not supported, then -EINVAL is returned.
|
||||
*
|
||||
* @s_std_output: set v4l2_std_id for video OUTPUT devices. This is ignored by
|
||||
* video input devices.
|
||||
*
|
||||
|
@ -321,22 +330,15 @@ struct v4l2_mbus_frame_desc {
|
|||
* @g_tvnorms_output: get v4l2_std_id with all standards supported by the video
|
||||
* OUTPUT device. This is ignored by video capture devices.
|
||||
*
|
||||
* @s_crystal_freq: sets the frequency of the crystal used to generate the
|
||||
* clocks in Hz. An extra flags field allows device specific configuration
|
||||
* regarding clock frequency dividers, etc. If not used, then set flags
|
||||
* to 0. If the frequency is not supported, then -EINVAL is returned.
|
||||
*
|
||||
* @g_input_status: get input status. Same as the status field in the v4l2_input
|
||||
* struct.
|
||||
*
|
||||
* @s_routing: see s_routing in audio_ops, except this version is for video
|
||||
* devices.
|
||||
*
|
||||
* @s_dv_timings(): Set custom dv timings in the sub device. This is used
|
||||
* when sub device is capable of setting detailed timing information
|
||||
* in the hardware to generate/detect the video signal.
|
||||
*
|
||||
* @g_dv_timings(): Get custom dv timings in the sub device.
|
||||
*
|
||||
* @g_mbus_config: get supported mediabus configurations
|
||||
*
|
||||
* @s_mbus_config: set a certain mediabus configuration. This operation is added
|
||||
|
|
Загрузка…
Ссылка в новой задаче