vfio/pci: Restore MSIx message prior to enabling

The MSIx vector table lives in device memory, which may be cleared as
part of a backdoor device reset. This is the case on the IBM IPR HBA
when the BIST is run on the device. When assigned to a QEMU guest,
the guest driver does a pci_save_state(), issues a BIST, then does a
pci_restore_state(). The BIST clears the MSIx vector table, but due
to the way interrupts are configured the pci_restore_state() does not
restore the vector table as expected. Eventually this results in an
EEH error on Power platforms when the device attempts to signal an
interrupt with the zero'd table entry.

Fix the problem by restoring the host cached MSI message prior to
enabling each vector.

Reported-by: Wen Xiong <wenxiong@linux.vnet.ibm.com>
Signed-off-by: Gavin Shan <gwshan@linux.vnet.ibm.com>
Signed-off-by: Alex Williamson <alex.williamson@redhat.com>

drivers/vfio/pci/vfio_pci_intrs.c

@@ -16,6 +16,7 @@
 #include <linux/device.h>
 #include <linux/interrupt.h>
 #include <linux/eventfd.h>
+#include <linux/msi.h>
 #include <linux/pci.h>
 #include <linux/file.h>
 #include <linux/poll.h>
@@ -548,6 +549,20 @@ static int vfio_msi_set_vector_signal(struct vfio_pci_device *vdev,
 		return PTR_ERR(trigger);
 	}
 
+	/*
+	 * The MSIx vector table resides in device memory which may be cleared
+	 * via backdoor resets. We don't allow direct access to the vector
+	 * table so even if a userspace driver attempts to save/restore around
+	 * such a reset it would be unsuccessful. To avoid this, restore the
+	 * cached value of the message prior to enabling.
+	 */
+	if (msix) {
+		struct msi_msg msg;
+
+		get_cached_msi_msg(irq, &msg);
+		write_msi_msg(irq, &msg);
+	}
+
 	ret = request_irq(irq, vfio_msihandler, 0,
 			  vdev->ctx[vector].name, trigger);
 	if (ret) {