pinctrl: rockchip: Add set_config callback support for gpiolib
Could only support PIN_CONFIG_INPUT_DEBOUNCE now as the HW block is too simple to support others. But even wrt. debounce capability, it now could only support very limited period of time to satisfy the real usecase. But still be useful to enable the crippled HW debounce to prevent any spurious glitches from waking up the system if the gpio is conguired as wakeup interrupt source. Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com> Reviewed-by: Heiko Stuebner <heiko@sntech.de> Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
Родитель
87065ca9b8
Коммит
b97038af5e
|
@ -2710,6 +2710,57 @@ static int rockchip_gpio_direction_output(struct gpio_chip *gc,
|
|||
return pinctrl_gpio_direction_output(gc->base + offset);
|
||||
}
|
||||
|
||||
static void rockchip_gpio_set_debounce(struct gpio_chip *gc,
|
||||
unsigned int offset, bool enable)
|
||||
{
|
||||
struct rockchip_pin_bank *bank = gpiochip_get_data(gc);
|
||||
void __iomem *reg = bank->reg_base + GPIO_DEBOUNCE;
|
||||
unsigned long flags;
|
||||
u32 data;
|
||||
|
||||
clk_enable(bank->clk);
|
||||
raw_spin_lock_irqsave(&bank->slock, flags);
|
||||
|
||||
data = readl(reg);
|
||||
if (enable)
|
||||
data |= BIT(offset);
|
||||
else
|
||||
data &= ~BIT(offset);
|
||||
writel(data, reg);
|
||||
|
||||
raw_spin_unlock_irqrestore(&bank->slock, flags);
|
||||
clk_disable(bank->clk);
|
||||
}
|
||||
|
||||
/*
|
||||
* gpiolib set_config callback function. The setting of the pin
|
||||
* mux function as 'gpio output' will be handled by the pinctrl subsystem
|
||||
* interface.
|
||||
*/
|
||||
static int rockchip_gpio_set_config(struct gpio_chip *gc, unsigned int offset,
|
||||
unsigned long config)
|
||||
{
|
||||
enum pin_config_param param = pinconf_to_config_param(config);
|
||||
|
||||
switch (param) {
|
||||
case PIN_CONFIG_INPUT_DEBOUNCE:
|
||||
rockchip_gpio_set_debounce(gc, offset, true);
|
||||
/*
|
||||
* Rockchip's gpio could only support up to one period
|
||||
* of the debounce clock(pclk), which is far away from
|
||||
* satisftying the requirement, as pclk is usually near
|
||||
* 100MHz shared by all peripherals. So the fact is it
|
||||
* has crippled debounce capability could only be useful
|
||||
* to prevent any spurious glitches from waking up the system
|
||||
* if the gpio is conguired as wakeup interrupt source. Let's
|
||||
* still return -ENOTSUPP as before, to make sure the caller
|
||||
* of gpiod_set_debounce won't change its behaviour.
|
||||
*/
|
||||
default:
|
||||
return -ENOTSUPP;
|
||||
}
|
||||
}
|
||||
|
||||
/*
|
||||
* gpiolib gpio_to_irq callback function. Creates a mapping between a GPIO pin
|
||||
* and a virtual IRQ, if not already present.
|
||||
|
@ -2735,6 +2786,7 @@ static const struct gpio_chip rockchip_gpiolib_chip = {
|
|||
.get_direction = rockchip_gpio_get_direction,
|
||||
.direction_input = rockchip_gpio_direction_input,
|
||||
.direction_output = rockchip_gpio_direction_output,
|
||||
.set_config = rockchip_gpio_set_config,
|
||||
.to_irq = rockchip_gpio_to_irq,
|
||||
.owner = THIS_MODULE,
|
||||
};
|
||||
|
|
Загрузка…
Ссылка в новой задаче