sfc: Make module parameters really boolean

Most of the module parameters treated as boolean are currently exposed
as type int or uint.  Defining them with the proper type is useful
documentation for both users and developers.

Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>

drivers/net/ethernet/sfc/efx.c

@@ -106,8 +106,8 @@ static struct workqueue_struct *reset_workqueue;
  *
  * This is only used in MSI-X interrupt mode
  */
-static unsigned int separate_tx_channels;
-module_param(separate_tx_channels, uint, 0444);
+static bool separate_tx_channels;
+module_param(separate_tx_channels, bool, 0444);
 MODULE_PARM_DESC(separate_tx_channels,
 		 "Use separate channels for TX and RX");
 
@@ -160,8 +160,8 @@ static unsigned int rss_cpus;
 module_param(rss_cpus, uint, 0444);
 MODULE_PARM_DESC(rss_cpus, "Number of CPUs to use for Receive-Side Scaling");
 
-static int phy_flash_cfg;
-module_param(phy_flash_cfg, int, 0644);
+static bool phy_flash_cfg;
+module_param(phy_flash_cfg, bool, 0644);
 MODULE_PARM_DESC(phy_flash_cfg, "Set PHYs into reflash mode initially");
 
 static unsigned irq_adapt_low_thresh = 8000;