arm64: dts: uniphier: add CPU clock and OPP table for LD11 SoC

Add a CPU clock to every CPU node and a CPU OPP table to use the
generic cpufreq driver.

Note:
clock-latency-ns (300ns) was calculated based on the CPU-gear switch
sequencer spec; it takes 12 clock cycles on the sequencer running
at 50 MHz, plus a bit additional latency.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Acked-by: Viresh Kumar <viresh.kumar@linaro.org>

arch/arm64/boot/dts/socionext/uniphier-ld11.dtsi

@@ -70,14 +70,52 @@
 			device_type = "cpu";
 			compatible = "arm,cortex-a53", "arm,armv8";
 			reg = <0 0x000>;
+			clocks = <&sys_clk 33>;
 			enable-method = "psci";
+			operating-points-v2 = <&cluster0_opp>;
 		};
 
 		cpu1: cpu@1 {
 			device_type = "cpu";
 			compatible = "arm,cortex-a53", "arm,armv8";
 			reg = <0 0x001>;
+			clocks = <&sys_clk 33>;
 			enable-method = "psci";
+			operating-points-v2 = <&cluster0_opp>;
+		};
+	};
+
+	cluster0_opp: opp_table {
+		compatible = "operating-points-v2";
+		opp-shared;
+
+		opp@245000000 {
+			opp-hz = /bits/ 64 <245000000>;
+			clock-latency-ns = <300>;
+		};
+		opp@250000000 {
+			opp-hz = /bits/ 64 <250000000>;
+			clock-latency-ns = <300>;
+		};
+		opp@490000000 {
+			opp-hz = /bits/ 64 <490000000>;
+			clock-latency-ns = <300>;
+		};
+		opp@500000000 {
+			opp-hz = /bits/ 64 <500000000>;
+			clock-latency-ns = <300>;
+		};
+		opp@653334000 {
+			opp-hz = /bits/ 64 <653334000>;
+			clock-latency-ns = <300>;
+		};
+		opp@666667000 {
+			opp-hz = /bits/ 64 <666667000>;
+			clock-latency-ns = <300>;
+		};
+		opp@980000000 {
+			opp-hz = /bits/ 64 <980000000>;
+			clock-latency-ns = <300>;
 		};
 	};