drm/i915/icl: do a posting read after irq install

When reading GEN11_GT_INTR_DWx closely after enabling the interrupts
in gen11_irq_postinstall, the returned value is garbage. This can
cause other parts of the setup code (e.g. gen11_reset_one_iir) to
think that there are interrupts to be cleared when there are none.

The garbage value is only seen on the first read done after the enable,
so this looks like a posting issue. Adding a posting read after enabling
the interrupts does indeed fix the problem.

Note that the posting read has been purposely added outside of
gen11_master_intr_enable since the issue has only been observed when the
full interrupt setup is performed.

Cc: Mika Kuoppala <mika.kuoppala@linux.intel.com>
Signed-off-by: Daniele Ceraolo Spurio <daniele.ceraolospurio@intel.com>
Acked-by: Chris Wilson <chris@chris-wilson.co.uk>
Acked-by: Mika Kuoppala <mika.kuoppala@linux.intel.com>
Signed-off-by: Mika Kuoppala <mika.kuoppala@linux.intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20190123023227.8117-1-daniele.ceraolospurio@intel.com

drivers/gpu/drm/i915/i915_irq.c

@@ -4089,6 +4089,7 @@ static int gen11_irq_postinstall(struct drm_device *dev)
 	I915_WRITE(GEN11_DISPLAY_INT_CTL, GEN11_DISPLAY_IRQ_ENABLE);
 
 	gen11_master_intr_enable(dev_priv->regs);
+	POSTING_READ(GEN11_GFX_MSTR_IRQ);
 
 	return 0;
 }