i2c: xlp9xx: Get clock frequency with clk API

Get the input clock frequency to the controller from the linux clk
API, if it is available. This allows us to pass in the block input
frequency either from ACPI (using APD) or from device tree.

The old hardcoded frequency is used as default for backwards compatibility.

Signed-off-by: Jayachandran C <jnair@caviumnetworks.com>
Signed-off-by: Kamlakant Patel <kamlakant.patel@cavium.com>
Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

drivers/i2c/busses/i2c-xlp9xx.c

@@ -7,6 +7,7 @@
  */
 
 #include <linux/acpi.h>
+#include <linux/clk.h>
 #include <linux/completion.h>
 #include <linux/i2c.h>
 #include <linux/init.h>
@@ -84,6 +85,7 @@ struct xlp9xx_i2c_dev {
 	u32 __iomem *base;
 	u32 msg_buf_remaining;
 	u32 msg_len;
+	u32 ip_clk_hz;
 	u32 clk_hz;
 	u32 msg_err;
 	u8 *msg_buf;
@@ -213,7 +215,7 @@ static int xlp9xx_i2c_init(struct xlp9xx_i2c_dev *priv)
 	 * The controller uses 5 * SCL clock internally.
 	 * So prescale value should be divided by 5.
 	 */
-	prescale = DIV_ROUND_UP(XLP9XX_I2C_IP_CLK_FREQ, priv->clk_hz);
+	prescale = DIV_ROUND_UP(priv->ip_clk_hz, priv->clk_hz);
 	prescale = ((prescale - 8) / 5) - 1;
 	xlp9xx_write_i2c_reg(priv, XLP9XX_I2C_CTRL, XLP9XX_I2C_CTRL_RST);
 	xlp9xx_write_i2c_reg(priv, XLP9XX_I2C_CTRL, XLP9XX_I2C_CTRL_EN |
@@ -342,9 +344,19 @@ static const struct i2c_algorithm xlp9xx_i2c_algo = {
 static int xlp9xx_i2c_get_frequency(struct platform_device *pdev,
 				    struct xlp9xx_i2c_dev *priv)
 {
+	struct clk *clk;
 	u32 freq;
 	int err;
 
+	clk = devm_clk_get(&pdev->dev, NULL);
+	if (IS_ERR(clk)) {
+		priv->ip_clk_hz = XLP9XX_I2C_IP_CLK_FREQ;
+		dev_dbg(&pdev->dev, "using default input frequency %u\n",
+			priv->ip_clk_hz);
+	} else {
+		priv->ip_clk_hz = clk_get_rate(clk);
+	}
+
 	err = device_property_read_u32(&pdev->dev, "clock-frequency", &freq);
 	if (err) {
 		freq = XLP9XX_I2C_DEFAULT_FREQ;