From c3e4b995e47e8f72297779852907f6d3ecd75139 Mon Sep 17 00:00:00 2001 From: Philip Avinash Date: Fri, 4 Jan 2013 13:26:49 +0530 Subject: [PATCH] mtd: nand: omap2: Update nerrors using ecc.strength Remove check of ecc bytes with 13, number of errors can directly update from nand ecc strength. This will increase re-usability of the code. Also add macro definitions BCH8_ERROR_MAX & BCH4_ERROR_MAX for better readability and cleaner code. Signed-off-by: Philip Avinash Signed-off-by: Artem Bityutskiy --- drivers/mtd/nand/omap2.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/drivers/mtd/nand/omap2.c b/drivers/mtd/nand/omap2.c index 0002d5e94f0d..ec20f67e8949 100644 --- a/drivers/mtd/nand/omap2.c +++ b/drivers/mtd/nand/omap2.c @@ -117,6 +117,9 @@ #define OMAP24XX_DMA_GPMC 4 +#define BCH8_MAX_ERROR 8 /* upto 8 bit correctable */ +#define BCH4_MAX_ERROR 4 /* upto 4 bit correctable */ + /* oob info generated runtime depending on ecc algorithm and layout selected */ static struct nand_ecclayout omap_oobinfo; /* Define some generic bad / good block scan pattern which are used @@ -1041,7 +1044,7 @@ static void omap3_enable_hwecc_bch(struct mtd_info *mtd, int mode) struct nand_chip *chip = mtd->priv; u32 val; - nerrors = (info->nand.ecc.bytes == 13) ? 8 : 4; + nerrors = info->nand.ecc.strength; dev_width = (chip->options & NAND_BUSWIDTH_16) ? 1 : 0; nsectors = 1; /* @@ -1218,13 +1221,14 @@ static int omap3_init_bch(struct mtd_info *mtd, int ecc_opt) struct omap_nand_info *info = container_of(mtd, struct omap_nand_info, mtd); #ifdef CONFIG_MTD_NAND_OMAP_BCH8 - const int hw_errors = 8; + const int hw_errors = BCH8_MAX_ERROR; #else - const int hw_errors = 4; + const int hw_errors = BCH4_MAX_ERROR; #endif info->bch = NULL; - max_errors = (ecc_opt == OMAP_ECC_BCH8_CODE_HW) ? 8 : 4; + max_errors = (ecc_opt == OMAP_ECC_BCH8_CODE_HW) ? + BCH8_MAX_ERROR : BCH4_MAX_ERROR; if (max_errors != hw_errors) { pr_err("cannot configure %d-bit BCH ecc, only %d-bit supported", max_errors, hw_errors);