PCI: Hotplug: fakephp: Return success, not ENODEV, when bus rescan is triggered

The 'power' attribute of the fakephp driver originally only let one turn a
slot off.  If one tried to turn a slot on (echo 1 > .../power), it would
return ENODEV, as fakephp did not support this function.

An old (pre-git) patch changed this:
2004/11/11 16:33:31-08:00 jdittmer
[PATCH] fakephp: add pci bus rescan ability
http://article.gmane.org/gmane.linux.kernel/251183

Now writing "1" to the power attribute has the effect of triggering a bus
rescan, but it still returns ENODEV, probably an oversight in the above
patch.

Using the BusyBox echo will not produce an error message, but will
trigger *two* bus rescans (and return an exit code of 1):
~ # strace echo -n 1 > /sys/bus/pci/slots/0000:00:00.0/power
...
write(1, "1", 1)                        = -1 ENODEV (No such device)
write(1, "1", 1)                        = -1 ENODEV (No such device)
exit(1)                                 = ?

Using cp gives a write error, even though the write did happen and a rescan
was triggered:
~ # echo -n 1 > tmp ; cp tmp /sys/bus/pci/slots/0000:00:00.0/power
cp: Write Error: No such device

It seems much better to return success instead of failure.  The actual
status of the bus rescan is hard to return.  It happens asynchronously in a
work thread, so the sysfs store functions returns before any status is
ready (the whole point of the work queue).  And even if it didn't do this,
the rescan doesn't have any clear status to return.

Signed-off-by: Trent Piepho <tpiepho@freescale.com>
CC: Jan Dittmer <jdittmer@ppp0.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/pci/hotplug/fakephp.c

@@ -293,7 +293,7 @@ static int enable_slot(struct hotplug_slot *hotplug_slot)
 	/* mis-use enable_slot for rescanning of the pci bus */
 	cancel_work_sync(&pci_rescan_work);
 	queue_work(dummyphp_wq, &pci_rescan_work);
-	return -ENODEV;
+	return 0;
 }
 
 /* find the hotplug_slot for the pci_dev */