mmc: make sdhci work with ricoh mmc controller

The current way of disabling it is not well tested by vendor and has all
kinds of bugs that show up on resume from ram/disk.  A very good example
is a dead SDHCI controller.

Old way of disabling is still supported by continuing to use
CONFIG_MMC_RICOH_MMC.

Based on 'http://list.drzeus.cx/pipermail/sdhci-devel/2007-December/002085.html'
Therefore most of the credit for this goes to Andrew de Quincey

Signed-off-by: Maxim Levitsky <maximlevitsky@gmail.com>
Cc: Andrew de Quincey <adq_dvb@lidskialf.net>
Acked-by: Philip Langdale <philipl@overt.org>
Cc: "Rafael J. Wysocki" <rjw@sisk.pl>
Cc: <linux-mmc@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/mmc/host/sdhci-pci.c

@@ -17,6 +17,7 @@
 #include <linux/pci.h>
 #include <linux/dma-mapping.h>
 #include <linux/slab.h>
+#include <linux/device.h>
 
 #include <linux/mmc/host.h>
 
@@ -84,7 +85,30 @@ static int ricoh_probe(struct sdhci_pci_chip *chip)
 	if (chip->pdev->subsystem_vendor == PCI_VENDOR_ID_SAMSUNG ||
 	    chip->pdev->subsystem_vendor == PCI_VENDOR_ID_SONY)
 		chip->quirks |= SDHCI_QUIRK_NO_CARD_NO_RESET;
+	return 0;
+}
 
+static int ricoh_mmc_probe_slot(struct sdhci_pci_slot *slot)
+{
+	slot->host->caps =
+		((0x21 << SDHCI_TIMEOUT_CLK_SHIFT)
+			& SDHCI_TIMEOUT_CLK_MASK) |
+
+		((0x21 << SDHCI_CLOCK_BASE_SHIFT)
+			& SDHCI_CLOCK_BASE_MASK) |
+
+		SDHCI_TIMEOUT_CLK_UNIT |
+		SDHCI_CAN_VDD_330 |
+		SDHCI_CAN_DO_SDMA;
+	return 0;
+}
+
+static int ricoh_mmc_resume(struct sdhci_pci_chip *chip)
+{
+	/* Apply a delay to allow controller to settle */
+	/* Otherwise it becomes confused if card state changed
+		during suspend */
+	msleep(500);
 	return 0;
 }
 
@@ -95,6 +119,15 @@ static const struct sdhci_pci_fixes sdhci_ricoh = {
 			  SDHCI_QUIRK_CLOCK_BEFORE_RESET,
 };
 
+static const struct sdhci_pci_fixes sdhci_ricoh_mmc = {
+	.probe_slot	= ricoh_mmc_probe_slot,
+	.resume		= ricoh_mmc_resume,
+	.quirks		= SDHCI_QUIRK_32BIT_DMA_ADDR |
+			  SDHCI_QUIRK_CLOCK_BEFORE_RESET |
+			  SDHCI_QUIRK_NO_CARD_NO_RESET |
+			  SDHCI_QUIRK_MISSING_CAPS
+};
+
 static const struct sdhci_pci_fixes sdhci_ene_712 = {
 	.quirks		= SDHCI_QUIRK_SINGLE_POWER_WRITE |
 			  SDHCI_QUIRK_BROKEN_DMA,
@@ -373,6 +406,14 @@ static const struct pci_device_id pci_ids[] __devinitdata = {
 		.driver_data	= (kernel_ulong_t)&sdhci_ricoh,
 	},
 
+	{
+		.vendor         = PCI_VENDOR_ID_RICOH,
+		.device         = 0x843,
+		.subvendor      = PCI_ANY_ID,
+		.subdevice      = PCI_ANY_ID,
+		.driver_data    = (kernel_ulong_t)&sdhci_ricoh_mmc,
+	},
+
 	{
 		.vendor		= PCI_VENDOR_ID_ENE,
 		.device		= PCI_DEVICE_ID_ENE_CB712_SD,

drivers/mmc/host/sdhci.c

@@ -1687,7 +1687,8 @@ int sdhci_add_host(struct sdhci_host *host)
 			host->version);
 	}
 
-	caps = sdhci_readl(host, SDHCI_CAPABILITIES);
+	caps = (host->quirks & SDHCI_QUIRK_MISSING_CAPS) ? host->caps :
+		sdhci_readl(host, SDHCI_CAPABILITIES);
 
 	if (host->quirks & SDHCI_QUIRK_FORCE_DMA)
 		host->flags |= SDHCI_USE_SDMA;

drivers/mmc/host/sdhci.h

@@ -240,6 +240,8 @@ struct sdhci_host {
 #define SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN		(1<<25)
 /* Controller cannot support End Attribute in NOP ADMA descriptor */
 #define SDHCI_QUIRK_NO_ENDATTR_IN_NOPDESC		(1<<26)
+/* Controller is missing device caps. Use caps provided by host */
+#define SDHCI_QUIRK_MISSING_CAPS			(1<<27)
 
 	int			irq;		/* Device IRQ */
 	void __iomem *		ioaddr;		/* Mapped address */
@@ -292,6 +294,8 @@ struct sdhci_host {
 
 	struct timer_list	timer;		/* Timer for timeouts */
 
+	unsigned int		caps;		/* Alternative capabilities */
+
 	unsigned long		private[0] ____cacheline_aligned;
 };