- Add pinctrl/GPIO/EINT node for mt8135.

- document binding for the PMIC wrapper
 - Add watchdog to mt6589
 -----BEGIN PGP SIGNATURE-----
 Version: GnuPG v1
 
 iQIcBAABAgAGBQJVGWI3AAoJELQ5Ylss8dNDWdkQAIsScJEKUMLuCVwnRxfbTN0I
 g/rFqgaZF1Zv4vKJyVtItoLH25mX3FSePBi7nutOtz3s1jTOJAb+ND8HMngR2/tM
 MJpo1dZ8voxF8AxfrOF/nX3pUVgzuLoYADGs3cPMk8D+SeRaMH+j+qk9/r3mcmut
 gJg3Zfmd+iOOFl+lki87N4PyFPZWYCHUYpmhDP+y/LjRA+rj2aApouzWJ+IpAmjX
 pMHx8dtRbhW4ht3G63sXkB/nmg5GSGVnQSjGn5qXusIJIhRE9NaV0ETGpDB4i4wh
 itWWM0czzflYGEGn1+uP0eld9y+RXYuEk/4SMomrKv5DA+0pN4jlFRvYgb9Ao24W
 nUYXWm0vrAFWs34WPIeO4Q8h1CbOqBxtgtW7u5Vx2kIN0IkNn8DP8OH7DaGul3nT
 Gz4zjezlts6p3T0ROMrOTeVaQ4rRUuBpGx4TJSo4AbuSgA/casYaCbn7rBVEwaI9
 wtqZw21rGQSnIqSTEBrplRFleaKoEt9j/+udWqcfW+bdw1bW9hv77+1fkdnjbfVl
 Aw4qA0NTW6Gfw7imdbUdTt9ENTPQ/i5Zxwt41OvRXwSC6KeEfxvxhh/QVznimf+T
 xFn15XFaa62KavRjl2nJL22PnauJgbS+qm5p4yJBvv6WhY9qkewvfpPcMGPmeJ7A
 4Pjg7vUjWzQV4PZgtKwg
 =suqC
 -----END PGP SIGNATURE-----

Merge tag 'v4.0-next-dts' of https://github.com/mbgg/linux-mediatek into next/dt

Merge "ARM: mediatek: dts updates for v4.1" from Matthias Brugger:

- Add pinctrl/GPIO/EINT node for mt8135.
- document binding for the PMIC wrapper
- Add watchdog to mt6589

* tag 'v4.0-next-dts' of https://github.com/mbgg/linux-mediatek:
  ARM: DTS: Add watchdog to mt6589
  dt-bindings: ARM: Mediatek: document binding for the PMIC wrapper
  ARM: dts: mt8135: Add pinctrl/GPIO/EINT node for mt8135.

Signed-off-by: Olof Johansson <olof@lixom.net>

Documentation/devicetree/bindings/soc/mediatek/pwrap.txt

@@ -0,0 +1,58 @@
+MediaTek PMIC Wrapper Driver
+
+This document describes the binding for the MediaTek PMIC wrapper.
+
+On MediaTek SoCs the PMIC is connected via SPI. The SPI master interface
+is not directly visible to the CPU, but only through the PMIC wrapper
+inside the SoC. The communication between the SoC and the PMIC can
+optionally be encrypted. Also a non standard Dual IO SPI mode can be
+used to increase speed.
+
+IP Pairing
+
+on MT8135 the pins of some SoC internal peripherals can be on the PMIC.
+The signals of these pins are routed over the SPI bus using the pwrap
+bridge. In the binding description below the properties needed for bridging
+are marked with "IP Pairing". These are optional on SoCs which do not support
+IP Pairing
+
+Required properties in pwrap device node.
+- compatible:
+	"mediatek,mt8135-pwrap" for MT8135 SoCs
+	"mediatek,mt8173-pwrap" for MT8173 SoCs
+- interrupts: IRQ for pwrap in SOC
+- reg-names: Must include the following entries:
+  "pwrap": Main registers base
+  "pwrap-bridge": bridge base (IP Pairing)
+- reg: Must contain an entry for each entry in reg-names.
+- reset-names: Must include the following entries:
+  "pwrap"
+  "pwrap-bridge" (IP Pairing)
+- resets: Must contain an entry for each entry in reset-names.
+- clock-names: Must include the following entries:
+  "spi": SPI bus clock
+  "wrap": Main module clock
+- clocks: Must contain an entry for each entry in clock-names.
+
+Optional properities:
+- pmic: Mediatek PMIC MFD is the child device of pwrap
+  See the following for child node definitions:
+  Documentation/devicetree/bindings/mfd/mt6397.txt
+
+Example:
+	pwrap: pwrap@1000f000 {
+		compatible = "mediatek,mt8135-pwrap";
+		reg = <0 0x1000f000 0 0x1000>,
+			<0 0x11017000 0 0x1000>;
+		reg-names = "pwrap", "pwrap-bridge";
+		interrupts = <GIC_SPI 128 IRQ_TYPE_LEVEL_HIGH>;
+		resets = <&infracfg MT8135_INFRA_PMIC_WRAP_RST>,
+				<&pericfg MT8135_PERI_PWRAP_BRIDGE_SW_RST>;
+		reset-names = "pwrap", "pwrap-bridge";
+		clocks = <&clk26m>, <&clk26m>;
+		clock-names = "spi", "wrap";
+
+		pmic {
+			compatible = "mediatek,mt6397";
+		};
+	};

arch/arm/boot/dts/mt6589.dtsi

@@ -138,5 +138,10 @@
 			clocks = <&uart_clk>;
 			status = "disabled";
 		};
+
+		wdt: watchdog@010000000 {
+			compatible = "mediatek,mt6589-wdt";
+			reg = <0x10000000 0x44>;
+		};
 	};
 };

arch/arm/boot/dts/mt8135.dtsi

@@ -15,6 +15,7 @@
 #include <dt-bindings/interrupt-controller/irq.h>
 #include <dt-bindings/interrupt-controller/arm-gic.h>
 #include "skeleton64.dtsi"
+#include "mt8135-pinfunc.h"
 
 / {
 	compatible = "mediatek,mt8135";
@@ -101,6 +102,30 @@
 		compatible = "simple-bus";
 		ranges;
 
+		syscfg_pctl_a: syscfg_pctl_a@10005000 {
+			compatible = "mediatek,mt8135-pctl-a-syscfg", "syscon";
+			reg = <0 0x10005000 0 0x1000>;
+		};
+
+		syscfg_pctl_b: syscfg_pctl_b@1020C000 {
+			compatible = "mediatek,mt8135-pctl-b-syscfg", "syscon";
+			reg = <0 0x1020C000 0 0x1000>;
+		};
+
+		pio: pinctrl@10005000 {
+			compatible = "mediatek,mt8135-pinctrl";
+			reg = <0 0x1000B000 0 0x1000>;
+			mediatek,pctl-regmap = <&syscfg_pctl_a &syscfg_pctl_b>;
+			pins-are-numbered;
+			gpio-controller;
+			#gpio-cells = <2>;
+			interrupt-controller;
+			#interrupt-cells = <2>;
+			interrupts = <GIC_SPI 116 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 117 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 118 IRQ_TYPE_LEVEL_HIGH>;
+		};
+
 		timer: timer@10008000 {
 			compatible = "mediatek,mt8135-timer",
 					"mediatek,mt6577-timer";