misc: hisi_hikey_usb: add support for Hikey 970
The HiKey 970 board is similar to Hikey 960 with regards to its USB configutation: it also relies on a USB HUB that is used when DWC3 is at host mode. However, it requires a few extra DT settings, as it uses a voltage regulator and GPIO reset pin. Add support for them. Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org> Link: https://lore.kernel.org/r/62843df9927b4d8dac5dc7c4a189567fa52ab2bb.1599717402.git.mchehab+huawei@kernel.org Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
This commit is contained in:
Mauro Carvalho Chehab
Greg Kroah-Hartman
Родитель
7a6ff4c4cb
Коммит
d210a00235
|
|
@ -457,13 +457,13 @@ config PVPANIC
|
|||
(guest) communicate panic events to the host.
|
||||
|
||||
config HISI_HIKEY_USB
|
||||
tristate "USB GPIO Hub on HiSilicon Hikey960 Platform"
|
||||
tristate "USB GPIO Hub on HiSilicon Hikey 960/970 Platform"
|
||||
depends on (OF && GPIOLIB) || COMPILE_TEST
|
||||
help
|
||||
If you say yes here this adds support for the on-board USB GPIO hub
|
||||
found on the HiKey960, which is necessary to support switching
|
||||
between the dual-role USB-C port and the USB-A host ports using only
|
||||
one USB controller.
|
||||
found on HiKey 960/970 boards, which is necessary to support
|
||||
switching between the dual-role USB-C port and the USB-A host ports
|
||||
using only one USB controller.
|
||||
|
||||
source "drivers/misc/c2port/Kconfig"
|
||||
source "drivers/misc/eeprom/Kconfig"
|
||||
|
|
|
|||
|
|
@ -14,8 +14,10 @@
|
|||
#include <linux/mod_devicetable.h>
|
||||
#include <linux/module.h>
|
||||
#include <linux/notifier.h>
|
||||
#include <linux/of_gpio.h>
|
||||
#include <linux/platform_device.h>
|
||||
#include <linux/property.h>
|
||||
#include <linux/regulator/consumer.h>
|
||||
#include <linux/slab.h>
|
||||
#include <linux/usb/role.h>
|
||||
|
||||
|
|
@ -29,9 +31,13 @@
|
|||
#define TYPEC_VBUS_POWER_OFF 0
|
||||
|
||||
struct hisi_hikey_usb {
|
||||
struct device *dev;
|
||||
struct gpio_desc *otg_switch;
|
||||
struct gpio_desc *typec_vbus;
|
||||
struct gpio_desc *hub_vbus;
|
||||
struct gpio_desc *reset;
|
||||
|
||||
struct regulator *regulator;
|
||||
|
||||
struct usb_role_switch *hub_role_sw;
|
||||
|
||||
|
|
@ -46,23 +52,47 @@ struct hisi_hikey_usb {
|
|||
|
||||
static void hub_power_ctrl(struct hisi_hikey_usb *hisi_hikey_usb, int value)
|
||||
{
|
||||
gpiod_set_value_cansleep(hisi_hikey_usb->hub_vbus, value);
|
||||
int ret, status;
|
||||
|
||||
if (hisi_hikey_usb->hub_vbus)
|
||||
gpiod_set_value_cansleep(hisi_hikey_usb->hub_vbus, value);
|
||||
|
||||
if (!hisi_hikey_usb->regulator)
|
||||
return;
|
||||
|
||||
status = regulator_is_enabled(hisi_hikey_usb->regulator);
|
||||
if (status == !!value)
|
||||
return;
|
||||
|
||||
if (value)
|
||||
ret = regulator_enable(hisi_hikey_usb->regulator);
|
||||
else
|
||||
ret = regulator_disable(hisi_hikey_usb->regulator);
|
||||
|
||||
if (ret)
|
||||
dev_err(hisi_hikey_usb->dev,
|
||||
"Can't switch regulator state to %s\n",
|
||||
value ? "enabled" : "disabled");
|
||||
}
|
||||
|
||||
static void usb_switch_ctrl(struct hisi_hikey_usb *hisi_hikey_usb,
|
||||
int switch_to)
|
||||
{
|
||||
if (!hisi_hikey_usb->otg_switch)
|
||||
return;
|
||||
|
||||
gpiod_set_value_cansleep(hisi_hikey_usb->otg_switch, switch_to);
|
||||
}
|
||||
|
||||
static void usb_typec_power_ctrl(struct hisi_hikey_usb *hisi_hikey_usb,
|
||||
int value)
|
||||
{
|
||||
if (!hisi_hikey_usb->typec_vbus)
|
||||
return;
|
||||
|
||||
gpiod_set_value_cansleep(hisi_hikey_usb->typec_vbus, value);
|
||||
}
|
||||
|
||||
|
||||
|
||||
static void relay_set_role_switch(struct work_struct *work)
|
||||
{
|
||||
struct hisi_hikey_usb *hisi_hikey_usb = container_of(work,
|
||||
|
|
@ -117,31 +147,70 @@ static int hub_usb_role_switch_set(struct usb_role_switch *sw, enum usb_role rol
|
|||
return 0;
|
||||
}
|
||||
|
||||
static int hisi_hikey_usb_parse_kirin970(struct platform_device *pdev,
|
||||
struct hisi_hikey_usb *hisi_hikey_usb)
|
||||
{
|
||||
struct regulator *regulator;
|
||||
int ret;
|
||||
|
||||
regulator = devm_regulator_get(&pdev->dev, "hub-vdd");
|
||||
if (IS_ERR(regulator)) {
|
||||
if (PTR_ERR(regulator) == -EPROBE_DEFER) {
|
||||
dev_info(&pdev->dev,
|
||||
"waiting for hub-vdd-supply to be probed\n");
|
||||
return PTR_ERR(regulator);
|
||||
}
|
||||
dev_err(&pdev->dev,
|
||||
"get hub-vdd-supply failed with error %ld\n",
|
||||
PTR_ERR(regulator));
|
||||
return PTR_ERR(regulator);
|
||||
}
|
||||
hisi_hikey_usb->regulator = regulator;
|
||||
|
||||
hisi_hikey_usb->reset = devm_gpiod_get(&pdev->dev, "hub_reset_en_gpio",
|
||||
GPIOD_OUT_HIGH);
|
||||
if (IS_ERR(hisi_hikey_usb->reset))
|
||||
return PTR_ERR(hisi_hikey_usb->reset);
|
||||
|
||||
return ret;
|
||||
}
|
||||
|
||||
static int hisi_hikey_usb_probe(struct platform_device *pdev)
|
||||
{
|
||||
struct device *dev = &pdev->dev;
|
||||
struct hisi_hikey_usb *hisi_hikey_usb;
|
||||
struct usb_role_switch_desc hub_role_switch = {NULL};
|
||||
int ret;
|
||||
|
||||
hisi_hikey_usb = devm_kzalloc(dev, sizeof(*hisi_hikey_usb), GFP_KERNEL);
|
||||
if (!hisi_hikey_usb)
|
||||
return -ENOMEM;
|
||||
|
||||
hisi_hikey_usb->typec_vbus = devm_gpiod_get(dev, "typec-vbus",
|
||||
GPIOD_OUT_LOW);
|
||||
if (IS_ERR(hisi_hikey_usb->typec_vbus))
|
||||
return PTR_ERR(hisi_hikey_usb->typec_vbus);
|
||||
hisi_hikey_usb->dev = &pdev->dev;
|
||||
|
||||
hisi_hikey_usb->otg_switch = devm_gpiod_get(dev, "otg-switch",
|
||||
GPIOD_OUT_HIGH);
|
||||
if (IS_ERR(hisi_hikey_usb->otg_switch))
|
||||
return PTR_ERR(hisi_hikey_usb->otg_switch);
|
||||
|
||||
/* hub-vdd33-en is optional */
|
||||
hisi_hikey_usb->hub_vbus = devm_gpiod_get_optional(dev, "hub-vdd33-en",
|
||||
GPIOD_OUT_HIGH);
|
||||
if (IS_ERR(hisi_hikey_usb->hub_vbus))
|
||||
return PTR_ERR(hisi_hikey_usb->hub_vbus);
|
||||
hisi_hikey_usb->typec_vbus = devm_gpiod_get(dev, "typec-vbus",
|
||||
GPIOD_OUT_LOW);
|
||||
if (IS_ERR(hisi_hikey_usb->typec_vbus))
|
||||
return PTR_ERR(hisi_hikey_usb->typec_vbus);
|
||||
|
||||
/* Parse Kirin 970-specific OF data */
|
||||
if (of_device_is_compatible(pdev->dev.of_node,
|
||||
"hisilicon,kirin970_hikey_usbhub")) {
|
||||
ret = hisi_hikey_usb_parse_kirin970(pdev, hisi_hikey_usb);
|
||||
if (ret)
|
||||
return ret;
|
||||
} else {
|
||||
/* hub-vdd33-en is optional */
|
||||
hisi_hikey_usb->hub_vbus = devm_gpiod_get_optional(dev, "hub-vdd33-en",
|
||||
GPIOD_OUT_HIGH);
|
||||
if (IS_ERR(hisi_hikey_usb->hub_vbus))
|
||||
return PTR_ERR(hisi_hikey_usb->hub_vbus);
|
||||
}
|
||||
|
||||
hisi_hikey_usb->dev_role_sw = usb_role_switch_get(dev);
|
||||
if (!hisi_hikey_usb->dev_role_sw)
|
||||
|
|
@ -149,7 +218,6 @@ static int hisi_hikey_usb_probe(struct platform_device *pdev)
|
|||
if (IS_ERR(hisi_hikey_usb->dev_role_sw))
|
||||
return PTR_ERR(hisi_hikey_usb->dev_role_sw);
|
||||
|
||||
|
||||
INIT_WORK(&hisi_hikey_usb->work, relay_set_role_switch);
|
||||
mutex_init(&hisi_hikey_usb->lock);
|
||||
|
||||
|
|
@ -158,7 +226,7 @@ static int hisi_hikey_usb_probe(struct platform_device *pdev)
|
|||
hub_role_switch.driver_data = hisi_hikey_usb;
|
||||
|
||||
hisi_hikey_usb->hub_role_sw = usb_role_switch_register(dev,
|
||||
&hub_role_switch);
|
||||
&hub_role_switch);
|
||||
|
||||
if (IS_ERR(hisi_hikey_usb->hub_role_sw)) {
|
||||
usb_role_switch_put(hisi_hikey_usb->dev_role_sw);
|
||||
|
|
@ -184,7 +252,8 @@ static int hisi_hikey_usb_remove(struct platform_device *pdev)
|
|||
}
|
||||
|
||||
static const struct of_device_id id_table_hisi_hikey_usb[] = {
|
||||
{.compatible = "hisilicon,gpio_hubv1"},
|
||||
{ .compatible = "hisilicon,gpio_hubv1" },
|
||||
{ .compatible = "hisilicon,kirin970_hikey_usbhub" },
|
||||
{}
|
||||
};
|
||||
MODULE_DEVICE_TABLE(of, id_table_hisi_hikey_usb);
|
||||
|
|
|
|||
Загрузка…
Ссылка в новой задаче