USB: EHCI: Safe endianness for transfer buffers after reset in case of HUB with TT

This patch fixes the endianness select for transfer buffers in EHCI
controllers that have Transaction Translator built in the hub.  Also I
cleaned it up to make rid of magic numbers.

Signed-off-by: Vladimir Barinov <vbarinov@ru.mvista.com>
Cc: <david-b@pacbell.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/usb/host/ehci-hcd.c

@@ -201,9 +201,15 @@ static void tdi_reset (struct ehci_hcd *ehci)
 	u32 __iomem	*reg_ptr;
 	u32		tmp;
 
-	reg_ptr = (u32 __iomem *)(((u8 __iomem *)ehci->regs) + 0x68);
+	reg_ptr = (u32 __iomem *)(((u8 __iomem *)ehci->regs) + USBMODE);
 	tmp = ehci_readl(ehci, reg_ptr);
-	tmp |= 0x3;
+	tmp |= USBMODE_CM_HC;
+	/* The default byte access to MMR space is LE after
+	 * controller reset. Set the required endian mode
+	 * for transfer buffers to match the host microprocessor
+	 */
+	if (ehci_big_endian_mmio(ehci))
+		tmp |= USBMODE_BE;
 	ehci_writel(ehci, tmp, reg_ptr);
 }
 

drivers/usb/host/ehci.h

@@ -302,6 +302,12 @@ struct ehci_regs {
 #define PORT_RWC_BITS   (PORT_CSC | PORT_PEC | PORT_OCC)
 } __attribute__ ((packed));
 
+#define USBMODE		0x68		/* USB Device mode */
+#define USBMODE_SDIS	(1<<3)		/* Stream disable */
+#define USBMODE_BE	(1<<2)		/* BE/LE endianness select */
+#define USBMODE_CM_HC	(3<<0)		/* host controller mode */
+#define USBMODE_CM_IDLE	(0<<0)		/* idle state */
+
 /* Appendix C, Debug port ... intended for use with special "debug devices"
  * that can help if there's no serial console.  (nonstandard enumeration.)
  */