net: mvpp2: reconfiguring the port interface is PPv2.2 specific

This patch adds a check on the PPv2 version in-use not to reconfigure
the port mode when an interface is updated when using PPv2.1 as the
functions called are PPv2.2 specific.

Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c

@@ -4672,17 +4672,15 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
 
 	/* Make sure the port is disabled when reconfiguring the mode */
 	mvpp2_port_disable(port);
-	if (change_interface) {
+	if (port->priv->hw_version == MVPP22 && change_interface) {
 		mvpp22_gop_mask_irq(port);
 
-		if (port->priv->hw_version == MVPP22) {
 		port->phy_interface = state->interface;
 
 		/* Reconfigure the serdes lanes */
 		phy_power_off(port->comphy);
 		mvpp22_mode_reconfigure(port);
 	}
-	}
 
 	/* mac (re)configuration */
 	if (mvpp2_is_xlg(state->interface))
@@ -4695,7 +4693,7 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
 	if (port->priv->hw_version == MVPP21 && port->flags & MVPP2_F_LOOPBACK)
 		mvpp2_port_loopback_set(port, state);
 
-	if (change_interface)
+	if (port->priv->hw_version == MVPP22 && change_interface)
 		mvpp22_gop_unmask_irq(port);
 
 	mvpp2_port_enable(port);