arm64: dts: rockchip: hook up bluetooth at uart0 on rockpro64

With enabled wifi support (required for firmware loading) for the
Ampak AP6359SA based wifi/bt combo module we now also can enable
the bluetooth part.

Suggested-by: Heiko Stuebner <heiko@sntech.de>
Signed-off-by: Soeren Moch <smoch@web.de>
Link: https://lore.kernel.org/r/20191218223523.30154-3-smoch@web.de
Signed-off-by: Heiko Stuebner <heiko@sntech.de>

arch/arm64/boot/dts/rockchip/rk3399-rockpro64.dtsi

@@ -543,6 +543,20 @@
 };
 
 &pinctrl {
+	bt {
+		bt_enable_h: bt-enable-h {
+			rockchip,pins = <0 RK_PB1 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
+
+		bt_host_wake_l: bt-host-wake-l {
+			rockchip,pins = <0 RK_PA4 RK_FUNC_GPIO &pcfg_pull_down>;
+		};
+
+		bt_wake_l: bt-wake-l {
+			rockchip,pins = <2 RK_PD3 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
+	};
+
 	buttons {
 		pwrbtn: pwrbtn {
 			rockchip,pins = <0 RK_PA5 RK_FUNC_GPIO &pcfg_pull_up>;
@@ -711,8 +725,21 @@
 
 &uart0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart0_xfer &uart0_cts>;
+	pinctrl-0 = <&uart0_xfer &uart0_cts &uart0_rts>;
 	status = "okay";
+
+	bluetooth {
+		compatible = "brcm,bcm43438-bt";
+		clocks = <&rk808 1>;
+		clock-names = "lpo";
+		device-wakeup-gpios = <&gpio2 RK_PD3 GPIO_ACTIVE_HIGH>;
+		host-wakeup-gpios = <&gpio0 RK_PA4 GPIO_ACTIVE_HIGH>;
+		shutdown-gpios = <&gpio0 RK_PB1 GPIO_ACTIVE_HIGH>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&bt_host_wake_l &bt_wake_l &bt_enable_h>;
+		vbat-supply = <&vcc3v3_sys>;
+		vddio-supply = <&vcc_1v8>;
+	};
 };
 
 &uart2 {