arm64: dts: qcom: sm8250: fix number of pins in 'gpio-ranges'

The last cell of 'gpio-ranges' should be number of GPIO pins, and in
case of qcom platform it should match msm_pinctrl_soc_data.ngpio rather
than msm_pinctrl_soc_data.ngpio - 1.

This fixes the problem that when the last GPIO pin in the range is
configured with the following call sequence, it always fails with
-EPROBE_DEFER.

    pinctrl_gpio_set_config()
        pinctrl_get_device_gpio_range()
            pinctrl_match_gpio_range()

Fixes: 16951b490b ("arm64: dts: qcom: sm8250: Add TLMM pinctrl node")
Cc: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
Link: https://lore.kernel.org/r/20210303033106.549-4-shawn.guo@linaro.org
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>

arch/arm64/boot/dts/qcom/sm8250.dtsi

@@ -2689,7 +2689,7 @@
 			#gpio-cells = <2>;
 			interrupt-controller;
 			#interrupt-cells = <2>;
-			gpio-ranges = <&tlmm 0 0 180>;
+			gpio-ranges = <&tlmm 0 0 181>;
 			wakeup-parent = <&pdc>;
 
 			pri_mi2s_active: pri-mi2s-active {