Blackfin: swap clocksource ratings for gptimer/cycles

The cycles clocksource is a higher resolution than the gptimer one, so
make sure the ratings field reflects this.

Signed-off-by: Graf Yang <graf.yang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

arch/blackfin/Kconfig

@@ -648,7 +648,7 @@ config CYCLES_CLOCKSOURCE
 	  writing the registers will most likely crash the kernel.
 
 config GPTMR0_CLOCKSOURCE
-	bool "Use GPTimer0 as a clocksource (higher rating)"
+	bool "Use GPTimer0 as a clocksource"
 	select BFIN_GPTIMERS
 	depends on GENERIC_CLOCKEVENTS
 	depends on !TICKSOURCE_GPTMR0

arch/blackfin/kernel/time-ts.c

@@ -66,7 +66,7 @@ static cycle_t bfin_read_cycles(struct clocksource *cs)
 
 static struct clocksource bfin_cs_cycles = {
 	.name		= "bfin_cs_cycles",
-	.rating		= 350,
+	.rating		= 400,
 	.read		= bfin_read_cycles,
 	.mask		= CLOCKSOURCE_MASK(64),
 	.shift		= 22,
@@ -115,7 +115,7 @@ static cycle_t bfin_read_gptimer0(void)
 
 static struct clocksource bfin_cs_gptimer0 = {
 	.name		= "bfin_cs_gptimer0",
-	.rating		= 400,
+	.rating		= 350,
 	.read		= bfin_read_gptimer0,
 	.mask		= CLOCKSOURCE_MASK(32),
 	.shift		= 22,