spi: spidev: fix a debug message value

The debug message in spidev_message() can show wrong xfer speed.
It happens if the initial (came from DT) and set with ioctl call spidev
speeds are different (spidev->speed_hz != spi->max_speed_hz) and one
sends a message with ioctl call and the field of speed is uninitialized
(u_tmp->speed_hz == 0).

In this case the kernel shows the spi->max_speed_hz value instead of
correct spidev->speed_hz.
...
set the max speed with an ioctl call:
[ 1227.702714] spidev spi0.0: setup mode 0, 32 bits/w, 20000000 Hz max --> 0
(real speed sets to 20000000Hz)
send a message with an ioctl call:
[ 1227.731801] spidev spi0.0:   xfer len 4096 tx 32bits 0 usec 10000000Hz
(debug message shows 10000000Hz that is the original max speed of this
spidev came from DT)
...

Fix the data source for the debug message.

Signed-off-by: Oleksandr Suvorov <oleksandr.suvorov@toradex.com>
Link: https://lore.kernel.org/r/20200229161841.89144-2-oleksandr.suvorov@toradex.com
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spidev.c

@@ -275,14 +275,14 @@ static int spidev_message(struct spidev_data *spidev,
 #ifdef VERBOSE
 		dev_dbg(&spidev->spi->dev,
 			"  xfer len %u %s%s%s%dbits %u usec %u usec %uHz\n",
-			u_tmp->len,
-			u_tmp->rx_buf ? "rx " : "",
-			u_tmp->tx_buf ? "tx " : "",
-			u_tmp->cs_change ? "cs " : "",
-			u_tmp->bits_per_word ? : spidev->spi->bits_per_word,
-			u_tmp->delay_usecs,
-			u_tmp->word_delay_usecs,
-			u_tmp->speed_hz ? : spidev->spi->max_speed_hz);
+			k_tmp->len,
+			k_tmp->rx_buf ? "rx " : "",
+			k_tmp->tx_buf ? "tx " : "",
+			k_tmp->cs_change ? "cs " : "",
+			k_tmp->bits_per_word ? : spidev->spi->bits_per_word,
+			k_tmp->delay.value,
+			k_tmp->word_delay.value,
+			k_tmp->speed_hz ? : spidev->spi->max_speed_hz);
 #endif
 		spi_message_add_tail(k_tmp, &msg);
 	}