media: camss: csid-170: set the right HALT_CMD when disabled

Use the "HALT_CMD_RESUME_AT_FRAME_BOUNDARY" define instead of a "1" which
is otherwise confusing, and add a "HALT_CMD_HALT_AT_FRAME_BOUNDARY" which
is set when disabling.

Fixes: eebe6d00e9 ("media: camss: Add support for CSID hardware version Titan 170")
Signed-off-by: Jonathan Marek <jonathan@marek.ca>
Reviewed-by: Robert Foss <robert.foss@linaro.org>
Tested-by: Julian Grahsl <jgrahsl@snap.com>
Tested-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>

drivers/media/platform/qcom/camss/camss-csid-170.c

@@ -105,7 +105,8 @@
 #define CSID_RDI_CTRL(rdi)			((IS_LITE ? 0x208 : 0x308)\
 						+ 0x100 * (rdi))
 #define		RDI_CTRL_HALT_CMD		0
-#define			ALT_CMD_RESUME_AT_FRAME_BOUNDARY	1
+#define			HALT_CMD_HALT_AT_FRAME_BOUNDARY		0
+#define			HALT_CMD_RESUME_AT_FRAME_BOUNDARY	1
 #define		RDI_CTRL_HALT_MODE		2
 
 #define CSID_RDI_FRM_DROP_PATTERN(rdi)			((IS_LITE ? 0x20C : 0x30C)\
@@ -444,7 +445,10 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
 	val |= 1 << CSI2_RX_CFG1_MISR_EN;
 	writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
 
-	val = 1 << RDI_CTRL_HALT_CMD;
+	if (enable)
+		val = HALT_CMD_RESUME_AT_FRAME_BOUNDARY << RDI_CTRL_HALT_CMD;
+	else
+		val = HALT_CMD_HALT_AT_FRAME_BOUNDARY << RDI_CTRL_HALT_CMD;
 	writel_relaxed(val, csid->base + CSID_RDI_CTRL(0));
 }