rtl8xxxu: Add rtl8723bu_phy_init_antenna_selection()

So far this is just for 8723BU. It includes writing to a number of
registers I have seen no description for so far.

0x0064
0x0930
0x0944

Signed-off-by: Jes Sorensen <Jes.Sorensen@redhat.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>

drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c

@@ -2670,6 +2670,38 @@ static void rtl8xxxu_firmware_self_reset(struct rtl8xxxu_priv *priv)
 	}
 }
 
+static void rtl8723bu_phy_init_antenna_selection(struct rtl8xxxu_priv *priv)
+{
+	u32 val32;
+
+	val32 = rtl8xxxu_read32(priv, 0x64);
+	val32 &= ~(BIT(20) | BIT(24));
+	rtl8xxxu_write32(priv, 0x64, val32);
+
+	val32 = rtl8xxxu_read32(priv, REG_GPIO_MUXCFG);
+	val32 &= ~BIT(4);
+	val32 |= BIT(3);
+	rtl8xxxu_write32(priv, REG_GPIO_MUXCFG, val32);
+
+	val32 = rtl8xxxu_read32(priv, REG_LEDCFG0);
+	val32 &= ~BIT(23);
+	val32 |= BIT(24);
+	rtl8xxxu_write32(priv, REG_LEDCFG0, val32);
+
+	val32 = rtl8xxxu_read32(priv, 0x0944);
+	val32 |= (BIT(0) | BIT(1));
+	rtl8xxxu_write32(priv, 0x0944, val32);
+
+	val32 = rtl8xxxu_read32(priv, 0x0930);
+	val32 &= 0xffffff00;
+	val32 |= 0x77;
+	rtl8xxxu_write32(priv, 0x0930, val32);
+
+	val32 = rtl8xxxu_read32(priv, REG_PWR_DATA);
+	val32 |= BIT(11);
+	rtl8xxxu_write32(priv, REG_PWR_DATA, val32);
+}
+
 static int
 rtl8xxxu_init_mac(struct rtl8xxxu_priv *priv, struct rtl8xxxu_reg8val *array)
 {
@@ -4621,6 +4653,9 @@ static int rtl8xxxu_init_device(struct ieee80211_hw *hw)
 		rtl8xxxu_write32(priv, REG_HIMR1, 0x00);
 	}
 
+	if (priv->fops->phy_init_antenna_selection)
+		priv->fops->phy_init_antenna_selection(priv);
+
 	ret = rtl8xxxu_init_mac(priv, rtl8723a_mac_init_table);
 	dev_dbg(dev, "%s: init_mac %i\n", __func__, ret);
 	if (ret)
@@ -6380,6 +6415,7 @@ static struct rtl8xxxu_fileops rtl8723bu_fops = {
 	.load_firmware = rtl8723bu_load_firmware,
 	.power_on = rtl8723au_power_on,
 	.llt_init = rtl8xxxu_auto_llt_table,
+	.phy_init_antenna_selection = rtl8723bu_phy_init_antenna_selection,
 	.writeN_block_size = 1024,
 };
 

drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h

@@ -764,5 +764,6 @@ struct rtl8xxxu_fileops {
 	int (*load_firmware) (struct rtl8xxxu_priv *priv);
 	int (*power_on) (struct rtl8xxxu_priv *priv);
 	int (*llt_init) (struct rtl8xxxu_priv *priv, u8 last_tx_page);
+	void (*phy_init_antenna_selection) (struct rtl8xxxu_priv *priv);
 	int writeN_block_size;
 };