PCI: keystone: Use generic DesignWare accessors

The dw_pcie_readl_rc() and dw_pcie_writel_rc() interfaces already add in
pp->dbi_base, so use those instead of doing it ourselves in the keystone
driver.  No functional change intended.

Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>

drivers/pci/host/pci-keystone-dw.c

@@ -362,8 +362,8 @@ void ks_dw_pcie_setup_rc_app_regs(struct keystone_pcie *ks_pcie)
 
 	/* Disable BARs for inbound access */
 	ks_dw_pcie_set_dbi_mode(ks_pcie->va_app_base);
-	writel(0, pp->dbi_base + PCI_BASE_ADDRESS_0);
-	writel(0, pp->dbi_base + PCI_BASE_ADDRESS_1);
+	dw_pcie_writel_rc(pp, PCI_BASE_ADDRESS_0, 0);
+	dw_pcie_writel_rc(pp, PCI_BASE_ADDRESS_1, 0);
 	ks_dw_pcie_clear_dbi_mode(ks_pcie->va_app_base);
 
 	/* Set outbound translation size per window division */
@@ -461,8 +461,8 @@ void ks_dw_pcie_v3_65_scan_bus(struct pcie_port *pp)
 	ks_dw_pcie_set_dbi_mode(ks_pcie->va_app_base);
 
 	/* Enable BAR0 */
-	writel(1, pp->dbi_base + PCI_BASE_ADDRESS_0);
-	writel(SZ_4K - 1, pp->dbi_base + PCI_BASE_ADDRESS_0);
+	dw_pcie_writel_rc(pp, PCI_BASE_ADDRESS_0, 1);
+	dw_pcie_writel_rc(pp, PCI_BASE_ADDRESS_0, SZ_4K - 1);
 
 	ks_dw_pcie_clear_dbi_mode(ks_pcie->va_app_base);
 
@@ -470,7 +470,7 @@ void ks_dw_pcie_v3_65_scan_bus(struct pcie_port *pp)
 	  * For BAR0, just setting bus address for inbound writes (MSI) should
 	  * be sufficient.  Use physical address to avoid any conflicts.
 	  */
-	writel(ks_pcie->app.start, pp->dbi_base + PCI_BASE_ADDRESS_0);
+	dw_pcie_writel_rc(pp, PCI_BASE_ADDRESS_0, ks_pcie->app.start);
 }
 
 /**
@@ -478,8 +478,9 @@ void ks_dw_pcie_v3_65_scan_bus(struct pcie_port *pp)
  */
 int ks_dw_pcie_link_up(struct pcie_port *pp)
 {
-	u32 val = readl(pp->dbi_base + DEBUG0);
+	u32 val;
 
+	val = dw_pcie_readl_rc(pp, DEBUG0);
 	return (val & LTSSM_STATE_MASK) == LTSSM_STATE_L0;
 }