ASoC: pxa: mioa701_wm9713: Convert to table based DAPM setup
Use table based setup to register the DAPM widgets and routes. This on one hand makes the code a bit cleaner and on the other hand the board level DAPM elements get registered in the card's DAPM context rather than in the CODEC's DAPM context. Also remove the snd_soc_dapm_enable_pin() calls, since pins are enabled by default and there are no matching snd_soc_dapm_disable_pin() calls. Signed-off-by: Lars-Peter Clausen <lars@metafoo.de> Signed-off-by: Mark Brown <broonie@linaro.org>
This commit is contained in:
Родитель
1bdd301f79
Коммит
f6b2a04590
|
@ -127,16 +127,8 @@ static const struct snd_soc_dapm_route audio_map[] = {
|
|||
static int mioa701_wm9713_init(struct snd_soc_pcm_runtime *rtd)
|
||||
{
|
||||
struct snd_soc_codec *codec = rtd->codec;
|
||||
struct snd_soc_dapm_context *dapm = &codec->dapm;
|
||||
unsigned short reg;
|
||||
|
||||
/* Add mioa701 specific widgets */
|
||||
snd_soc_dapm_new_controls(dapm, mioa701_dapm_widgets,
|
||||
ARRAY_SIZE(mioa701_dapm_widgets));
|
||||
|
||||
/* Set up mioa701 specific audio path audio_mapnects */
|
||||
snd_soc_dapm_add_routes(dapm, audio_map, ARRAY_SIZE(audio_map));
|
||||
|
||||
/* Prepare GPIO8 for rear speaker amplifier */
|
||||
reg = codec->driver->read(codec, AC97_GPIO_CFG);
|
||||
codec->driver->write(codec, AC97_GPIO_CFG, reg | 0x0100);
|
||||
|
@ -145,12 +137,6 @@ static int mioa701_wm9713_init(struct snd_soc_pcm_runtime *rtd)
|
|||
reg = codec->driver->read(codec, AC97_3D_CONTROL);
|
||||
codec->driver->write(codec, AC97_3D_CONTROL, reg | 0xc000);
|
||||
|
||||
snd_soc_dapm_enable_pin(dapm, "Front Speaker");
|
||||
snd_soc_dapm_enable_pin(dapm, "Rear Speaker");
|
||||
snd_soc_dapm_enable_pin(dapm, "Front Mic");
|
||||
snd_soc_dapm_enable_pin(dapm, "GSM Line In");
|
||||
snd_soc_dapm_enable_pin(dapm, "GSM Line Out");
|
||||
|
||||
return 0;
|
||||
}
|
||||
|
||||
|
@ -183,6 +169,11 @@ static struct snd_soc_card mioa701 = {
|
|||
.owner = THIS_MODULE,
|
||||
.dai_link = mioa701_dai,
|
||||
.num_links = ARRAY_SIZE(mioa701_dai),
|
||||
|
||||
.dapm_widgets = mioa701_dapm_widgets,
|
||||
.num_dapm_widgets = ARRAY_SIZE(mioa701_dapm_widgets),
|
||||
.dapm_routes = audio_map,
|
||||
.num_dapm_routes = ARRAY_SIZE(audio_map),
|
||||
};
|
||||
|
||||
static int mioa701_wm9713_probe(struct platform_device *pdev)
|
||||
|
|
Загрузка…
Ссылка в новой задаче