staging: dgnc: remove useless variable 'intr_count'

The 'intr_count' variable was used only for increasing.
So the 'intr_count' variable is not useful for this driver.

Signed-off-by: Daeseok Youn <daeseok.youn@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/staging/dgnc/dgnc_cls.c

@@ -990,8 +990,6 @@ static irqreturn_t cls_intr(int irq, void *voidbrd)
 
 	spin_lock_irqsave(&brd->bd_intr_lock, flags);
 
-	brd->intr_count++;
-
 	/*
 	 * Check the board's global interrupt offset to see if we
 	 * we actually do have an interrupt pending for us.

drivers/staging/dgnc/dgnc_driver.h

@@ -183,7 +183,6 @@ struct dgnc_board {
 	uint		nasync;		/* Number of ports on card */
 
 	uint		irq;		/* Interrupt request number */
-	ulong		intr_count;	/* Count of interrupts */
 	ulong		intr_modem;	/* Count of interrupts */
 	ulong		intr_tx;	/* Count of interrupts */
 	ulong		intr_rx;	/* Count of interrupts */

drivers/staging/dgnc/dgnc_neo.c

@@ -926,8 +926,6 @@ static irqreturn_t neo_intr(int irq, void *voidbrd)
 	if (!brd || brd->magic != DGNC_BOARD_MAGIC)
 		return IRQ_NONE;
 
-	brd->intr_count++;
-
 	/* Lock out the slow poller from running on this board. */
 	spin_lock_irqsave(&brd->bd_intr_lock, flags);