net: fix some trailing whitespaces
Signed-off-by: Graf Yang <graf.yang@analog.com> Signed-off-by: Bryan Wu <cooloney@kernel.org> Signed-off-by: David S. Miller <davem@davemloft.net>
This commit is contained in:
Родитель
33dccbb050
Коммит
fe2918b098
|
@ -17,7 +17,7 @@
|
|||
* as published by the Free Software Foundation; either version
|
||||
* 2 of the License, or (at your option) any later version.
|
||||
*/
|
||||
|
||||
|
||||
#ifndef _LINUX_IF_ETHER_H
|
||||
#define _LINUX_IF_ETHER_H
|
||||
|
||||
|
@ -25,7 +25,7 @@
|
|||
|
||||
/*
|
||||
* IEEE 802.3 Ethernet magic constants. The frame sizes omit the preamble
|
||||
* and FCS/CRC (frame check sequence).
|
||||
* and FCS/CRC (frame check sequence).
|
||||
*/
|
||||
|
||||
#define ETH_ALEN 6 /* Octets in one ethernet addr */
|
||||
|
@ -83,7 +83,7 @@
|
|||
/*
|
||||
* Non DIX types. Won't clash for 1500 types.
|
||||
*/
|
||||
|
||||
|
||||
#define ETH_P_802_3 0x0001 /* Dummy type for 802.3 frames */
|
||||
#define ETH_P_AX25 0x0002 /* Dummy protocol id for AX.25 */
|
||||
#define ETH_P_ALL 0x0003 /* Every packet (be careful!!!) */
|
||||
|
@ -109,7 +109,7 @@
|
|||
/*
|
||||
* This is an Ethernet frame header.
|
||||
*/
|
||||
|
||||
|
||||
struct ethhdr {
|
||||
unsigned char h_dest[ETH_ALEN]; /* destination eth addr */
|
||||
unsigned char h_source[ETH_ALEN]; /* source ether addr */
|
||||
|
|
|
@ -96,7 +96,7 @@ struct wireless_dev;
|
|||
* Compute the worst case header length according to the protocols
|
||||
* used.
|
||||
*/
|
||||
|
||||
|
||||
#if defined(CONFIG_WLAN_80211) || defined(CONFIG_AX25) || defined(CONFIG_AX25_MODULE)
|
||||
# if defined(CONFIG_MAC80211_MESH)
|
||||
# define LL_MAX_HEADER 128
|
||||
|
@ -124,7 +124,7 @@ struct wireless_dev;
|
|||
* Network device statistics. Akin to the 2.0 ether stats but
|
||||
* with byte counters.
|
||||
*/
|
||||
|
||||
|
||||
struct net_device_stats
|
||||
{
|
||||
unsigned long rx_packets; /* total packets received */
|
||||
|
@ -285,7 +285,7 @@ enum netdev_state_t
|
|||
|
||||
/*
|
||||
* This structure holds at boot time configured netdevice settings. They
|
||||
* are then used in the device probing.
|
||||
* are then used in the device probing.
|
||||
*/
|
||||
struct netdev_boot_setup {
|
||||
char name[IFNAMSIZ];
|
||||
|
@ -740,7 +740,7 @@ struct net_device
|
|||
void *dsa_ptr; /* dsa specific data */
|
||||
#endif
|
||||
void *atalk_ptr; /* AppleTalk link */
|
||||
void *ip_ptr; /* IPv4 specific data */
|
||||
void *ip_ptr; /* IPv4 specific data */
|
||||
void *dn_ptr; /* DECnet specific data */
|
||||
void *ip6_ptr; /* IPv6 specific data */
|
||||
void *ec_ptr; /* Econet specific data */
|
||||
|
@ -753,7 +753,7 @@ struct net_device
|
|||
*/
|
||||
unsigned long last_rx; /* Time of last Rx */
|
||||
/* Interface address info used in eth_type_trans() */
|
||||
unsigned char dev_addr[MAX_ADDR_LEN]; /* hw address, (before bcast
|
||||
unsigned char dev_addr[MAX_ADDR_LEN]; /* hw address, (before bcast
|
||||
because most packets are unicast) */
|
||||
|
||||
unsigned char broadcast[MAX_ADDR_LEN]; /* hw bcast add */
|
||||
|
|
Загрузка…
Ссылка в новой задаче