Граф коммитов

12 Коммитов

Автор SHA1 Сообщение Дата
Benjamin Herrenschmidt cec08e7a94 [POWERPC] vmemmap fixes to use smaller pages
This changes vmemmap to use a different region (region 0xf) of the
address space, and to configure the page size of that region
dynamically at boot.

The problem with the current approach of always using 16M pages is that
it's not well suited to machines that have small amounts of memory such
as small partitions on pseries, or PS3's.

In fact, on the PS3, failure to allocate the 16M page backing vmmemmap
tends to prevent hotplugging the HV's "additional" memory, thus limiting
the available memory even more, from my experience down to something
like 80M total, which makes it really not very useable.

The logic used by my match to choose the vmemmap page size is:

 - If 16M pages are available and there's 1G or more RAM at boot,
   use that size.
 - Else if 64K pages are available, use that
 - Else use 4K pages

I've tested on a POWER6 (16M pages) and on an iSeries POWER3 (4K pages)
and it seems to work fine.

Note that I intend to change the way we organize the kernel regions &
SLBs so the actual region will change from 0xf back to something else at
one point, as I simplify the SLB miss handler, but that will be for a
later patch.

Signed-off-by: Paul Mackerras <paulus@samba.org>
2008-05-15 20:49:25 +10:00
Michael Neuling 584f8b71a2 [POWERPC] Use SLB size from the device tree
Currently we hardwire the number of SLBs to 64, but PAPR says we
should use the ibm,slb-size property to obtain the number of SLB
entries.  This uses this property instead of assuming 64.  If no
property is found, we assume 64 entries as before.

This soft patches the SLB handler, so it shouldn't change performance
at all.

Signed-off-by: Michael Neuling <mikey@neuling.org>
Signed-off-by: Paul Mackerras <paulus@samba.org>
2007-12-11 13:45:56 +11:00
Paul Mackerras 1189be6508 [POWERPC] Use 1TB segments
This makes the kernel use 1TB segments for all kernel mappings and for
user addresses of 1TB and above, on machines which support them
(currently POWER5+, POWER6 and PA6T).

We detect that the machine supports 1TB segments by looking at the
ibm,processor-segment-sizes property in the device tree.

We don't currently use 1TB segments for user addresses < 1T, since
that would effectively prevent 32-bit processes from using huge pages
unless we also had a way to revert to using 256MB segments.  That
would be possible but would involve extra complications (such as
keeping track of which segment size was used when HPTEs were inserted)
and is not addressed here.

Parts of this patch were originally written by Ben Herrenschmidt.

Signed-off-by: Paul Mackerras <paulus@samba.org>
2007-10-12 14:05:17 +10:00
Benjamin Herrenschmidt d0f13e3c20 [POWERPC] Introduce address space "slices"
The basic issue is to be able to do what hugetlbfs does but with
different page sizes for some other special filesystems; more
specifically, my need is:

 - Huge pages

 - SPE local store mappings using 64K pages on a 4K base page size
kernel on Cell

 - Some special 4K segments in 64K-page kernels for mapping a dodgy
type of powerpc-specific infiniband hardware that requires 4K MMU
mappings for various reasons I won't explain here.

The main issues are:

 - To maintain/keep track of the page size per "segment" (as we can
only have one page size per segment on powerpc, which are 256MB
divisions of the address space).

 - To make sure special mappings stay within their allotted
"segments" (including MAP_FIXED crap)

 - To make sure everybody else doesn't mmap/brk/grow_stack into a
"segment" that is used for a special mapping

Some of the necessary mechanisms to handle that were present in the
hugetlbfs code, but mostly in ways not suitable for anything else.

The patch relies on some changes to the generic get_unmapped_area()
that just got merged.  It still hijacks hugetlb callbacks here or
there as the generic code hasn't been entirely cleaned up yet but
that shouldn't be a problem.

So what is a slice ?  Well, I re-used the mechanism used formerly by our
hugetlbfs implementation which divides the address space in
"meta-segments" which I called "slices".  The division is done using
256MB slices below 4G, and 1T slices above.  Thus the address space is
divided currently into 16 "low" slices and 16 "high" slices.  (Special
case: high slice 0 is the area between 4G and 1T).

Doing so simplifies significantly the tracking of segments and avoids
having to keep track of all the 256MB segments in the address space.

While I used the "concepts" of hugetlbfs, I mostly re-implemented
everything in a more generic way and "ported" hugetlbfs to it.

Slices can have an associated page size, which is encoded in the mmu
context and used by the SLB miss handler to set the segment sizes.  The
hash code currently doesn't care, it has a specific check for hugepages,
though I might add a mechanism to provide per-slice hash mapping
functions in the future.

The slice code provide a pair of "generic" get_unmapped_area() (bottomup
and topdown) functions that should work with any slice size.  There is
some trickiness here so I would appreciate people to have a look at the
implementation of these and let me know if I got something wrong.

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Paul Mackerras <paulus@samba.org>
2007-05-09 16:35:00 +10:00
Stephen Rothwell 3f639ee8c5 [POWERPC] implement BEGIN/END_FW_FTR_SECTION
and use it an all the obvious places in assembler code.

Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
2006-10-03 16:50:21 +10:00
Jörn Engel 6ab3d5624e Remove obsolete #include <linux/config.h>
Signed-off-by: Jörn Engel <joern@wohnheim.fh-wedel.de>
Signed-off-by: Adrian Bunk <bunk@stusta.de>
2006-06-30 19:25:36 +02:00
Paul Mackerras bf72aeba2f powerpc: Use 64k pages without needing cache-inhibited large pages
Some POWER5+ machines can do 64k hardware pages for normal memory but
not for cache-inhibited pages.  This patch lets us use 64k hardware
pages for most user processes on such machines (assuming the kernel
has been configured with CONFIG_PPC_64K_PAGES=y).  User processes
start out using 64k pages and get switched to 4k pages if they use any
non-cacheable mappings.

With this, we use 64k pages for the vmalloc region and 4k pages for
the imalloc region.  If anything creates a non-cacheable mapping in
the vmalloc region, the vmalloc region will get switched to 4k pages.
I don't know of any driver other than the DRM that would do this,
though, and these machines don't have AGP.

When a region gets switched from 64k pages to 4k pages, we do not have
to clear out all the 64k HPTEs from the hash table immediately.  We
use the _PAGE_COMBO bit in the Linux PTE to indicate whether the page
was hashed in as a 64k page or a set of 4k pages.  If hash_page is
trying to insert a 4k page for a Linux PTE and it sees that it has
already been inserted as a 64k page, it first invalidates the 64k HPTE
before inserting the 4k HPTE.  The hash invalidation routines also use
the _PAGE_COMBO bit, to determine whether to look for a 64k HPTE or a
set of 4k HPTEs to remove.  With those two changes, we can tolerate a
mix of 4k and 64k HPTEs in the hash table, and they will all get
removed when the address space is torn down.

Signed-off-by: Paul Mackerras <paulus@samba.org>
2006-06-15 10:45:18 +10:00
Jon Mason 2ef9481e66 [PATCH] powerpc: trivial: modify comments to refer to new location of files
This patch removes all self references and fixes references to files
in the now defunct arch/ppc64 tree.  I think this accomplises
everything wanted, though there might be a few references I missed.

Signed-off-by: Jon Mason <jdmason@us.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
2006-02-10 16:53:51 +11:00
Michael Ellerman b5666f7039 [PATCH] powerpc: Separate usage of KERNELBASE and PAGE_OFFSET
This patch separates usage of KERNELBASE and PAGE_OFFSET. I haven't
looked at any of the PPC32 code, if we ever want to support Kdump on
PPC we'll have to do another audit, ditto for iSeries.

This patch makes PAGE_OFFSET the constant, it'll always be 0xC * 1
gazillion for 64-bit.

To get a physical address from a virtual one you subtract PAGE_OFFSET,
_not_ KERNELBASE.

KERNELBASE is the virtual address of the start of the kernel, it's
often the same as PAGE_OFFSET, but _might not be_.

If you want to know something's offset from the start of the kernel
you should subtract KERNELBASE.

Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Signed-off-by: Paul Mackerras <paulus@samba.org>
2006-01-09 14:51:54 +11:00
David Gibson 7d24f0b8a5 [PATCH] ppc64: Fix bug in SLB miss handler for hugepages
This patch, however, should be applied on top of the 64k-page-size patch to
fix some problems with hugepage (some pre-existing, another introduced by
this patch).

The patch fixes a bug in the SLB miss handler for hugepages on ppc64
introduced by the dynamic hugepage patch (commit id
c594adad56) due to a misunderstanding of the
srd instruction's behaviour (mea culpa).  The problem arises when a 64-bit
process maps some hugepages in the low 4GB of the address space (unusual).
In this case, as well as the 256M segment in question being marked for
hugepages, other segments at 32G intervals will be incorrectly marked for
hugepages.

In the process, this patch tweaks the semantics of the hugepage bitmaps to
be more sensible.  Previously, an address below 4G was marked for hugepages
if the appropriate segment bit in the "low areas" bitmask was set *or* if
the low bit in the "high areas" bitmap was set (which would mark all
addresses below 1TB for hugepage).  With this patch, any given address is
governed by a single bitmap.  Addresses below 4GB are marked for hugepage
if and only if their bit is set in the "low areas" bitmap (256M
granularity).  Addresses between 4GB and 1TB are marked for hugepage iff
the low bit in the "high areas" bitmap is set.  Higher addresses are marked
for hugepage iff their bit in the "high areas" bitmap is set (1TB
granularity).

To avoid conflicts, this patch must be applied on top of BenH's pending
patch for 64k base page size [0].  As such, this patch also addresses a
hugepage problem introduced by that patch.  That patch allows hugepages of
1MB in size on hardware which supports it, however, that won't work when
using 4k pages (4 level pagetable), because in that case hugepage PTEs are
stored at the PMD level, and each PMD entry maps 2MB.  This patch simply
disallows hugepages in that case (we can do something cleverer to re-enable
them some other day).

Built, booted, and a handful of hugepage related tests passed on POWER5
LPAR (both ARCH=powerpc and ARCH=ppc64).

[0] http://gate.crashing.org/~benh/ppc64-64k-pages.diff

Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Paul Mackerras <paulus@samba.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-11-07 07:53:23 -08:00
Benjamin Herrenschmidt 3c726f8dee [PATCH] ppc64: support 64k pages
Adds a new CONFIG_PPC_64K_PAGES which, when enabled, changes the kernel
base page size to 64K.  The resulting kernel still boots on any
hardware.  On current machines with 4K pages support only, the kernel
will maintain 16 "subpages" for each 64K page transparently.

Note that while real 64K capable HW has been tested, the current patch
will not enable it yet as such hardware is not released yet, and I'm
still verifying with the firmware architects the proper to get the
information from the newer hypervisors.

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
2005-11-06 16:56:47 -08:00
Paul Mackerras ab1f9dac6e powerpc: Merge arch/ppc64/mm to arch/powerpc/mm
This moves the remaining files in arch/ppc64/mm to arch/powerpc/mm,
and arranges that we use them when compiling with ARCH=ppc64.

Signed-off-by: Paul Mackerras <paulus@samba.org>
2005-10-10 21:58:35 +10:00