This patch is intended to add a qdisc to support the new tx multiqueue
architecture by providing a band for each hardware queue. By doing
this it is possible to support a different qdisc per physical hardware
queue.
This qdisc uses the skb->queue_mapping to select which band to place
the traffic onto. It then uses a round robin w/ a check to see if the
subqueue is stopped to determine which band to dequeue the packet from.
Signed-off-by: Alexander Duyck <alexander.h.duyck@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add size table functions for qdiscs and calculate packet size in
qdisc_enqueue().
Based on patch by Patrick McHardy
http://marc.info/?l=linux-netdev&m=115201979221729&w=2
Signed-off-by: Jussi Kivilinna <jussi.kivilinna@mbnet.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
This actually fixes a bug added by the RR scheduler changes. The
->bands and ->prio2band parameters were being set outside of the
sch_tree_lock() and thus could result in strange behavior and
inconsistencies.
It might be possible, in the new design (where there will be one qdisc
per device TX queue) to allow similar functionality via a TX hash
algorithm for RR but I really see no reason to export this aspect of
how these multiqueue cards actually implement the scheduling of the
the individual DMA TX rings and the single physical MAC/PHY port.
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for dumping statistics and make internal queues visible as
classes.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This is done in order to, add support to changing the rate table to
use the upper-boundry L2T (length to time) value. Currently we use the
lower-boundry, which result in under-estimating the actual bandwidth
usage.
Extend the tc_ratespec struct, with two parameters: 1) "cell_align"
that allow adjusting the alignment of the rate table. 2) "overhead"
that allow adding a packet overhead before the lookup.
Signed-off-by: Jesper Dangaard Brouer <hawk@comx.dk>
Acked-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add the new sch_rr qdisc for multiqueue network device support. Allow
sch_prio and sch_rr to be compiled with or without multiqueue hardware
support.
sch_rr is part of sch_prio, and is referenced from MODULE_ALIAS. This
was done since sch_prio and sch_rr only differ in their dequeue
routine.
Signed-off-by: Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com>
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Here is a new feature for netem in 2.6.16. It adds the ability to
randomly corrupt packets with netem. A version was done by
Hagen Paul Pfeifer, but I redid it to handle the cases of backwards
compatibility with netlink interface and presence of hardware checksum
offload. It is useful for testing hardware offload in devices.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Introduces a new flag TC_RED_HARDDROP which specifies that if ECN
marking is enabled packets should still be dropped once the
average queue length exceeds the maximum threshold.
This _may_ help to avoid global synchronisation during small
bursts of peers advertising but not caring about ECN. Use this
option very carefully, it does more harm than good if
(qth_max - qth_min) does not cover at least two average burst
cycles.
The difference to the current behaviour, in which we'd run into
the hard queue limit, is that due to the low pass filter of RED
short bursts are less likely to cause a global synchronisation.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Adds a new u8 flags in a unused padding area of the netlink
message. Adds ECN marking support to be used instead of dropping
packets immediately.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Removes unnecessary includes, initializers, and simplifies
the code a bit.
Signed-off-by: Thomas Graf <tgraf@suug.ch>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Plug holes with padding fields and initialized them to zero.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Here is a fixed up version of the reorder feature of netem.
It is the same as the earlier patch plus with the bugfix from Julio merged in.
Has expected backwards compatibility behaviour.
Go ahead and merge this one, the TCP strangeness I was seeing was due
to the reordering bug, and previous version of TSO patch.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
Alexander Duyck
Jussi Kivilinna
David S. Miller
Patrick McHardy
Jesper Dangaard Brouer
Peter P Waskiewicz Jr
Stephen Hemminger
Thomas Graf
Linus Torvalds