The CONFIG_EXPERIMENTAL config item has not carried much meaning for a
while now and is almost always enabled by default. As agreed during the
Linux kernel summit, remove it from any "depends on" lines in Kconfigs.
CC: Gerrit Renker <gerrit@erg.abdn.ac.uk>
CC: "David S. Miller" <davem@davemloft.net>
Signed-off-by: Kees Cook <keescook@chromium.org>
Acked-by: David S. Miller <davem@davemloft.net>
Acked-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
This makes RTAX_RTO_MIN also available to CCID-3, replacing the compile-time
RTO lower bound with a per-route tunable value.
The original Kconfig option solved the problem that a very low RTT (in the
order of HZ) can trigger too frequent and unnecessary reductions of the
sending rate.
This tunable does not affect the initial RTO value of 2 seconds specified in
RFC 5348, section 4.2 and Appendix B. But like the hardcoded Kconfig value,
it allows to adapt to network conditions.
The same effect as the original Kconfig option of 100ms is now achieved by
> ip route replace to unicast 192.168.0.0/24 rto_min 100j dev eth0
(assuming HZ=1000).
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
No code change, cosmetical changes only:
* whitespace cleanup via scripts/cleanfile,
* remove self-references to filename at top of files,
* fix coding style (extraneous brackets),
* fix documentation style (kernel-doc-nano-HOWTO).
Thanks are due to Ivo Augusto Calado who raised these issues by
submitting good-quality patches.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
Thanks to Wei and Arnaldo for pointing out the correct
new reference for CCID-3.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch integrates the TFRC library, which is a dependency of CCID-3 (and
CCID-4), with the new use of CCIDs in the DCCP module.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
Based on Arnaldo's earlier patch, this patch integrates the standardised
CCID congestion control plugins (CCID-2 and CCID-3) of DCCP with dccp.ko:
* enables a faster connection path by eliminating the need to always go
through the CCID registration lock;
* updates the implementation to use only a single array whose size equals
the number of configured CCIDs instead of the maximum (256);
* since the CCIDs are now fixed array elements, synchronization is no
longer needed, simplifying use and implementation.
CCID-2 is suggested as minimum for a basic DCCP implementation (RFC 4340, 10);
CCID-3 is a standards-track CCID supported by RFC 4342 and RFC 5348.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch changes the tfrc_lib module in the following manner:
(1) a dedicated tfrc source file to call the packet history &
loss interval init/exit functions.
(2) a dedicated tfrc_pr_debug macro with toggle switch `tfrc_debug'.
Commiter note: renamed tfrc_module.c to tfrc.c, and made CONFIG_IP_DCCP_CCID3
select IP_DCCP_TFRC_LIB.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This cleans up the consequences of an earlier patch which
introduced the `if IP_DCCP' clause into net/dccp/Kconfig.
The CCID Kconfig menu is sourced within this clause; as a
consequence, all tests of type `depends on IP_DCCP' are now
redundant.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch addresses the following problems:
1. DCCP relies for its proper functioning on having at least one CCID module
enabled (as in TCP plugable congestion control). Currently it is possible to
disable both CCIDs and thus leave the DCCP module in a compiled, but entirely
non-functional state: no sockets can be created when no CCID is available.
Furthermore, the protocol is (again like TCP) not intended to be used without
CCIDs. Last, a non-empty CCID list is needed for doing CCID feature negotiation.
2. Internally the default CCID that is advertised by the Linux host is set to CCID2
(DCCPF_INITIAL_CCID in include/linux/dccp.h). Disabling CCID2 in the Kconfig
menu without changing the defaults leads to a failure `module not found' when
trying to load the dccp module (which internally tries to load the default CCID).
3. The specification (RFC 4340, sec. 10) treats CCID2 somewhat like a
`minimum common denominator'; the specification says that:
* "New connections start with CCID 2 for both endpoints"
* "A DCCP implementation intended for general use, such as an implementation in a
general-purpose operating system kernel, SHOULD implement at least CCID 2.
The intent is to make CCID 2 broadly available for interoperability [...]"
Providing CCID2 as minimum-required CCID (like Reno/Cubic in TCP) thus seems reasonable.
Hence this patch automatically selects CCID2 when DCCP is enabled. Documentation also added.
Discussions with Ian McDonald on this subject are gratefully acknowledged.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Ian McDonald <ian.mcdonald@jandi.co.nz>
Signed-off-by: Arnaldo Carvalho de Melo <acme@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The TFRC nofeedback timer normally expires after the maximum of 4
RTTs and twice the current send interval (RFC 3448, 4.3). On LANs
with a small RTT this can mean a high processing load and reduced
performance, since then the nofeedback timer is triggered very
frequently.
This patch provides a configuration option to set the bound for the
nofeedback timer, using as default 100 milliseconds.
By setting the configuration option to 0, strict RFC 3448 behaviour
can be enforced for the nofeedback timer.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This adds a CCID3 debug option to the configuration menu
which is missing in Kconfig, but already used by the code.
CCID 2 already provides such an entry.
To enable debugging, set CONFIG_IP_DCCP_CCID3_DEBUG=y
NOTE: The use of ccid3_{t,r}x_state_name is safe, since
now only enum values can appear.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
This patch
* makes debugging (when configured) work both for static / module build
* provides generic debugging macros for use in other DCCP / CCID modules
* adds missing information about debug parameters to Kconfig
* performs some code tidy-up
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Updates the references to spec documents throughout the code, taking into
account that
* the DCCP, CCID 2, and CCID 3 drafts all became RFCs in March this year
* RFC 1063 was obsoleted by RFC 1191
* draft-ietf-tcpimpl-pmtud-0x.txt was published as an Informational
RFC, RFC 2923 on 2000-09-22.
All references verified.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Allow the user to choose whether or not to enable CCID2 debugging via
Kconfig.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Make CCID2 and CCID3 default to what was selected for DCCP and use the
standard short description for the CCIDs (TCP-Like & TCP-Friendly).
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Original work by Andrea Bittau, Arnaldo Melo cleaned up and fixed several
issues on the merge process.
For now CCID2 was turned the default for all SOCK_DCCP connections, but this
will be remedied soon with the merge of the feature negotiation code.
Signed-off-by: Andrea Bittau <a.bittau@cs.ucl.ac.uk>
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
I'll now take a look at the other proposed TFRC DCCP CCIDs to find
more code that is now in ccid3.c and move to this module, the loss
event rate, calc_X, etc most probably will be moved there.
The main goal of these changes is to pave the way for the
implementation of more TFRC based DCCP CCIDs and to shrink ccid3.c,
reducing its complexity and helping in getting it rock solid.
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Development to this point was done on a subversion repository at:
http://oops.ghostprotocols.net:81/cgi-bin/viewcvs.cgi/dccp-2.6/
This repository will be kept at this site for the foreseable future,
so that interested parties can see the history of this code,
attributions, etc.
If I ever decide to take this offline I'll provide the full history at
some other suitable place.
Signed-off-by: Arnaldo Carvalho de Melo <acme@ghostprotocols.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Kees Cook
Gerrit Renker
Andrea Bittau
Arnaldo Carvalho de Melo
Arnaldo Carvalho de Melo