Add support for Texas Instruments' HCI Low Level (HCILL) Bluetooth
protocol, which is a power management extension to H4. The HCILL is
widely used by TI's BRF63xx Bluetooth chips.
Signed-off-by: Ohad Ben-Cohen <ohad@bencohen.org>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
With the new support for USB anchors the driver can become more
simpler and also cleaner. This patch switches to the usage of USB
anchors for all URBs.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
In case the remote entity tries to negogiate retransmission or flow
control mode, reject it and fall back to basic mode.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Indicate the support for the L2CAP features mask value when the remote
entity tries to negotiate Bluetooth 1.2 specific features.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
The Bluetooth 1.2 specification introduced a specific features mask
value to interoperate with newer versions of the specification. So far
this piece of information was never needed, but future extensions will
rely on it. This patch adds a generic way to retrieve this information
only once per connection setup.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
After the change to the L2CAP configuration parameter handling the
global conf_mtu variable is no longer needed and so remove it.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
The parameters of the L2CAP output configuration might not be accepted
after the first configuration round. So only indicate a finished output
configuration when acceptable settings are provided.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
The Bluetooth HCI commands are divided into logical OGF groups for
easier identification of their purposes. While this still makes sense
for the written specification, its makes the code only more complex
and harder to read. So instead of using separate OGF and OCF values
to identify the commands, use a common 16-bit opcode that combines
both values. As a side effect this also reduces the complexity of
OGF and OCF calculations during command header parsing.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
A few trivial Makefile cleanups
- dependencipes in head.o was all wrong - deleted
- CMODEL_CFLAG was not used anywhere
- NEW_GCC was then not used outside sparc64/Makefe - do not export it
- FIXME seems not appropriate - all other put oprofile in drivers-y too
- No reason to do -I. (and it still builds)
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Invoke the desc->handle_irq directly in the top-level dispatch,
just like other sophisticated ports.
This will allow us to decrease the cost of the MSI queue dispatch.
Signed-off-by: David S. Miller <davem@davemloft.net>
Not only Geyser 3 but also Geyser 1 need to be reset after they become
idle to stop them from needlessly waking up the kernel. Do idle reset
on all touchpads, regardless of their version - if we see 10 empty
packets the touchpad needs to be reset; good touchpads should not send
empty packets anyway.
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Add support for GoTop Super_Q2/GogoPen/PenPower tablets to usbtouchscreen.
Protocol discovery was done by Yick Yan Lam.
Signed-off-by: Daniel Ritz <daniel.ritz@gmx.ch>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Export the i8042_command() function which manages the mutual
exclusion with the help of the i8042_lock spinlock. This allows
to access i8042 safely from other parts of the kernel.
Signed-off-by: Márton Németh <nm127@freemail.hu>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
Use the watchdog timer to implement board restart support.
Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Add common helper routines: mpc52xx_map_wdt() and mpc52xx_restart().
Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Add 'fsl,' prefix to 'compatible' property for gpt nodes.
Add 'fsl,' prefix to empty, GPT0 specific 'has-wdt' property.
The fsl, prefix is being added to better match the convention of prefixing
manufacturer specific properties and values with the vendors name.
Signed-off-by: Marian Balakowicz <m8@semihalf.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Add helper routine mpc52xx_find_and_map_path(). Extract common code to
mpc52xx_map_node() and refactor mpc52xx_find_and_map().
Signed-off-by: Jan Wrobel <wrr@semihalf.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
* 'for-linus' of master.kernel.org:/pub/scm/linux/kernel/git/cooloney/blackfin-2.6:
Blackfin arch: update boards files
Blackfin arch: dma add some API and cleanup bf54x DMA definition
Blackfin arch: cleanup and promote the general purpose timers api to a core blackfin component
Blackfin arch: add a cheesy install target
Blackfin arch: add functions for converting between sclks and usecs
Blackfin arch: add assembly function for doing 64bit unsigned division
Blackfin arch: -mno-fdpic works
Blackfin arch: use "char bfin_board_name[]" rather than "char *bfin_board_name" per discussion on lkml as the former uses less storage
Blackfin arch: Fixing Bug: balance calls to get_task_mm with corresponding mmput calls
Blackfin serial driver Kconfig: depend on DMA not being enabled rather than a specific DMA size
Blackfin arch: Fix bug: missing CHIPID register field definition of BF54x
Blackfin arch: Fix up /proc/cpuinfo so it is like everyone else
Blackfin arch: Optimization - no need to make additional math here
Blackfin arch: force irq_flags into the .data section
Blackfin arch BF548 defconfig: enable watchdog by default
Blackfin arch: add new processor ADSP-BF52x arch/mach support
* 'audit.b43' of git://git.kernel.org/pub/scm/linux/kernel/git/viro/audit-current:
[PATCH] audit: watching subtrees
[PATCH] new helper - inotify_evict_watch()
[PATCH] new helper - inotify_clone_watch()
[PATCH] new helpers - collect_mounts() and release_collected_mounts()
[PATCH] pass dentry to audit_inode()/audit_inode_child()
This path mustn't have been tested :( I did attempt to exercise it
by injecting failures here, but I suspect PageMappedToDisk may have
been getting in the way. Will need more of a look, although I think
nobh mode is OK for an -rc1 (it shouldn't eat anyone's data).
Commit 03158cd7eb ("fs: restore nobh")
introcduced a NULL deref. Spotted by the Coverity checker.
Signed-off-by: Nick Piggin <npiggin@suse.de>
Cc: Badari Pulavarty <pbadari@us.ibm.com>
Cc: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
now that -mno-fdpic works, force it on so that
we can use any blackfin toolchain to build up the
kernel and kernel modules
wrap -mno-fdpic in $(call cc-option,-mno-fdpic) so that older
toolchains will still work
Signed-off-by: Mike Frysinger <michael.frysinger@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
We must balance calls to get_task_mm with corresponding mmput calls, otherwise
refcounting is screwed up and mms don't get freed when their task exits.
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
Fix up /proc/cpuinfo so it is like everyone else, and gets
parsed by various applications properly. Still needs some tweaking on
parts without full L1 sram, like 532, 531, so it doesn't print out L1
bank info that doesn't exist.
Signed-off-by: Robin Getz <robin.getz@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
force irq_flags into the .data section by initializing it to
the hardware masks that cannot be disabled. this way if we
use irq enable/disable functions before the .bss has been
zeroed out (as does our l1 relocate/dma functions), we dont
hit a problem where bss contains bogus crap.
Signed-off-by: Mike Frysinger <michael.frysinger@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
New kind of audit rule predicates: "object is visible in given subtree".
The part that can be sanely implemented, that is. Limitations:
* if you have hardlink from outside of tree, you'd better watch
it too (or just watch the object itself, obviously)
* if you mount something under a watched tree, tell audit
that new chunk should be added to watched subtrees
* if you umount something in a watched tree and it's still mounted
elsewhere, you will get matches on events happening there. New command
tells audit to recalculate the trees, trimming such sources of false
positives.
Note that it's _not_ about path - if something mounted in several places
(multiple mount, bindings, different namespaces, etc.), the match does
_not_ depend on which one we are using for access.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Get a snapshot of a subtree, creating private clones of vfsmounts
for all its components and release such snapshot resp.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
* 'master' of hera.kernel.org:/pub/scm/linux/kernel/git/kyle/parisc-2.6: (29 commits)
[PARISC] fix uninitialized variable warning in asm/rtc.h
[PARISC] Port checkstack.pl to parisc
[PARISC] Make palo target work when $obj != $src
[PARISC] Zap unused variable warnings in pci.c
[PARISC] Fix tests in palo target
[PARISC] Fix palo target
[PARISC] Restore palo target
[PARISC] Attempt to clean up parisc/Makefile
[PARISC] Fix infinite loop in /proc/iomem
[PARISC] Quiet sysfs_create_link __must_check warnings in pdc_stable
[PARISC] Squelch pci_enable_device __must_check warning in superio
[PARISC] Kill off broken irqstack code
[PARISC] Remove hardcoded uses of PAGE_SIZE
[PARISC] Clean up pointless ASM_PAGE_SIZE_DIV use
[PARISC] Kill off the last vestiges of ASM_PAGE_SIZE
[PARISC] Kill off ASM_PAGE_SIZE use
[PARISC] Beautify parisc vmlinux.lds.S
[PARISC] Clean up a resource_size_t warning in sba_iommu
[PARISC] Kill incorrect cast warning in unwinder
[PARISC] Kill zone_to_nid printk warning
...
Fixed trivial conflict in include/asm-parisc/tlbflush.h manually
* ssh://master.kernel.org/pub/scm/linux/kernel/git/sam/kbuild:
kbuild: restore arch/{ppc/xtensa}/boot cflags
kconfig: set title bar in xconfig
kbuild: fix toplevel Makefile/depmod