In preparation to enabling -Wimplicit-fallthrough, mark switch cases
where we are expecting to fall through.
Notice that in this particular case, I replaced the code comments with
a proper "fall through" annotation, which is what GCC is expecting
to find.
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Reviewed-by: Daniel Thompson <daniel.thompson@linaro.org>
Signed-off-by: Daniel Thompson <daniel.thompson@linaro.org>
This fixes the following problems:
1) Typematic-repeat of 'enter' gives warning message
and leaks make/break if KDB exits. Repeats
look something like 0x1c 0x1c .... 0x9c
2) Use of 'keypad enter' gives warning message and
leaks the ENTER break/make code out if KDB exits.
KP ENTER repeats look someting like 0xe0 0x1c
0xe0 0x1c ... 0xe0 0x9c.
3) Lag on the order of seconds between "break" and "make" when
expecting the enter "break" code. Seen under virtualized
environments such as VMware ESX.
The existing special enter handler tries to glob the enter break code,
but this fails if the other (KP) enter was used, or if there was a key
repeat. It also fails if you mashed some keys along with enter, and
you ended up with a non-enter make or non-enter break code coming
after the enter make code. So first, we modify the handler to handle
these cases. But performing these actions on every enter is annoying
since now you can't hold ENTER down to scroll <more>d messages in
KDB. Since this special behaviour is only necessary to handle the
exiting KDB ('g' + ENTER) without leaking scancodes to the OS. This
cleanup needs to get executed anytime the kdb_main loop exits.
Tested on QEMU. Set a bp on atkbd.c to verify no scan code was leaked.
Cc: Andrei Warkentin <andreiw@vmware.com>
[jason.wessel@windriver.com: move cleanup calls to kdb_main.c]
Signed-off-by: Andrei Warkentin <andrey.warkentin@gmail.com>
Signed-off-by: Jason Wessel <jason.wessel@windriver.com>
This patch adds in the kdb PS/2 keyboard driver. This was mostly a
direct port from the original kdb where I cleaned up the code against
checkpatch.pl and added the glue to stitch it into kgdb.
This patch also enables early kdb debug via kgdbwait and the keyboard.
All the access to configure kdb using either a serial console or the
keyboard is done via kgdboc.
If you want to use only the keyboard and want to break in early you
would add to your kernel command arguments:
kgdboc=kbd kgdbwait
If you wanted serial and or the keyboard access you could use:
kgdboc=kbd,ttyS0
You can also configure kgdboc as a kernel module or at run time with
the sysfs where you can activate and deactivate kgdb.
Turn it on:
echo kbd,ttyS0 > /sys/module/kgdboc/parameters/kgdboc
Turn it off:
echo "" > /sys/module/kgdboc/parameters/kgdboc
Signed-off-by: Jason Wessel <jason.wessel@windriver.com>
Reviewed-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>
Gustavo A. R. Silva
Andrei Warkentin
Jason Wessel