Not only PCI SSIDs but also look through codec SSIDs for fix-up table
entries. MacBook tend to give the same PCI SSID but unique codec SSIDs.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The ASUS EEE1601 works almost fine with the auto-parser but the static
configuration has a certain specific COEF verb. Add this to the fix-up
list so that we can drop the whole EEE1601 static config from
alc882_quirks.c.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Providing a pincfg fix for VAIO-TT with ALC889 codec to work with the
auto-parser, and drop the static configuration.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Now that model=ultra is supported well by the auto-parser, we can get rid
of the whole alc262_quirks.c and its related codes.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
A machine like Q1-ultra which has only a single HP but no mic-jack, we
can re-task the headhpone as an external mic jack. This was done formerly
in ALC262 model=ultra quirk, and now the auto-parser supports this mode.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
It works well with the auto-parse and the default BIOS setup when an
additional COEF setup (for benq) is used.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The conversion from ALC262 model=benq and model=benq-t31 static configs
to auto-parser requires the manual COEF setups for corresponding models.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The static quirks for ALC262 Lenovo 3000 can be covered by the auto-
parser with a fixup of the mic-pin to VREF50 and the additional COEF
verb.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Use the auto-parser for ALC262 model=toshiba-rx1 with the fixed pin-
configs. The BIOS table seems incorrect, so many pin entries are
overwritten to match with the former quirk.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When a Realtek codec has a matrix-style capture-source selection, we
need to scan all connections instead of only imux items. Otherwise some
input might be kept unmuted. Although the corresponding input must be
dead so there should be no input from it, it's still safer to mute the
route completely.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
* 'modsplit-Oct31_2011' of git://git.kernel.org/pub/scm/linux/kernel/git/paulg/linux: (230 commits)
Revert "tracing: Include module.h in define_trace.h"
irq: don't put module.h into irq.h for tracking irqgen modules.
bluetooth: macroize two small inlines to avoid module.h
ip_vs.h: fix implicit use of module_get/module_put from module.h
nf_conntrack.h: fix up fallout from implicit moduleparam.h presence
include: replace linux/module.h with "struct module" wherever possible
include: convert various register fcns to macros to avoid include chaining
crypto.h: remove unused crypto_tfm_alg_modname() inline
uwb.h: fix implicit use of asm/page.h for PAGE_SIZE
pm_runtime.h: explicitly requires notifier.h
linux/dmaengine.h: fix implicit use of bitmap.h and asm/page.h
miscdevice.h: fix up implicit use of lists and types
stop_machine.h: fix implicit use of smp.h for smp_processor_id
of: fix implicit use of errno.h in include/linux/of.h
of_platform.h: delete needless include <linux/module.h>
acpi: remove module.h include from platform/aclinux.h
miscdevice.h: delete unnecessary inclusion of module.h
device_cgroup.h: delete needless include <linux/module.h>
net: sch_generic remove redundant use of <linux/module.h>
net: inet_timewait_sock doesnt need <linux/module.h>
...
Fix up trivial conflicts (other header files, and removal of the ab3550 mfd driver) in
- drivers/media/dvb/frontends/dibx000_common.c
- drivers/media/video/{mt9m111.c,ov6650.c}
- drivers/mfd/ab3550-core.c
- include/linux/dmaengine.h
The 3.1 kernel has a regression for ALC861 codec where no sound output
is heard with the default setup. It's because the amps in DACs aren't
properly unmuted while the output mixers are assigned only to pins.
This patch fixes the missing initialization of DACs when no mixer is
assigned to them.
Tested-by: Andrea Iob <andrea_iob@yahoo.it>
Cc: <stable@kernel.org> [v3.1+]
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Some BIOS report invalid pins as digital output pins. The driver checks
the connection but it doesn't do it fully correctly, and it leaves some
undefined value as the audio-out widget, which makes the driver spewing
warnings. This patch fixes the issue.
Reference: https://bugzilla.novell.com/show_bug.cgi?id=727348
Cc: <stable@kernel.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When the driver finds multiple ADCs, it tries to create an alternative
capture PCM stream. However, these secondary ADCs might be useless or
in uncontrolled paths in some cases, e.g. when auto-mic or dynamic
ADC-switching is enabled. Also, when only a single capture source is
available, the multi-streams don't make sense, too.
With this patch, the driver checks such condition and skips the alt
stream appropriately.
Cc: <stable@kernel.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Lots of sound drivers were getting module.h via the implicit presence
of it in <linux/device.h> but we are going to clean that up. So
fix up those users now.
Signed-off-by: Paul Gortmaker <paul.gortmaker@windriver.com>
ALC260 has multiple mixer widgets connected to the shared DAC, but the
driver currently doesn't check this possibility and ignores when the DAC
is shared with others. This resulted in the silent output from some
routes because of lack of the amp setup.
This patch adds the workaround for it by checking the route even with the
shared DAC, but also checking the conflict with the existing control for
the very same widget NID.
Reference: https://bugzilla.novell.com/show_bug.cgi?id=726812
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The association numbers of surround/CLFE speaker pins aren't correctly
mapped by the auto-parser. This patch fixes the CLFE speaker pin to the
right assoc value (from 3 to 1).
Tested-by: Nika Topolchanskaya <nanodesuu@gmail.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The revision 0x100300 was found for ALC662. It seems to work well
with patch_alc662.
Cc: stable@kernel.org
BugLink: http://bugs.launchpad.net/bugs/877373
Tested-by: Shengyao Xue <Shengyao.xue@canonical.com>
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Acked-by: Kailang Yang <kailang@realtek.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When a device has multiple speakers and still has the auto-mute support,
the driver copies line_outs[] to speaker_outs[]. And then it tries to
assign DACs for both. This ended up with the assignment only to the
primary DAC to all speakers.
This patch fixes the situation by checking the duplicated LO/SPK case
appropriately.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The COEF #0 value represents a sort of device id, so it's supposedly
constant while operation. Better to use the cached value instead of
reading it at each time from the performance POV.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Use a static table for detecting the codec renames.
Also clean up the error paths in each patch_*() function.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
This typo caused headphone pins not to be initialized correctly.
BugLink: https://bugs.launchpad.net/bugs/871582
Reported-by: Effenberg
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When the speaker outputs are more than the headphone outputs, it implies
that the system has surround speakers while the headphones are only for
monitoring the front. In such a case, it's better to put speakers as
the primary outputs so that the driver can build up and keep the
surround setup. Otherwise the system will pick up the headphone as
primary, and offers less channels than the speakers do support.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The spec->autocfg.line_out_pins[] may contain the same pins as hp_pins[]
depending on the configuration. When they are identical, detecting the
line_jack_present flag screws up the auto-mute because alc_line_automute()
is called unconditionally at initialization while it won't be triggered
by unsol events, thus the old line_jack_present flag is kept for the
whole run.
For fixing this buggy behavior, the driver needs to check whether the
line-outs are really individual, and skip if same as headphone jacks.
Reference: https://bugzilla.novell.com/show_bug.cgi?id=716104
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When the headphone pin is assigned as primary output to line_out_pins[],
the automatic HP-pin assignment by ASSID must be suppressed. Otherwise
a wrong pin might be assigned to the headphone and breaks the auto-mute.
Reference: https://bugzilla.novell.com/show_bug.cgi?id=716104
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: <stable@kernel.org>
Increase readability and understandability in the automute code.
Signed-off-by: David Henningsson <david.henningsson@canonical.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When the system has only the headphone and the line-out jacks without
speakers, the current auto-mute code doesn't work. It's because the
spec->automute_lines flag is wrongly referred in update_speakers().
This flag must be meaningless when spec->automute_hp_lo isn't set, thus
they should be always coupled.
The patch fixes the problem and add a comment to indicate the
relationship briefly.
BugLink: http://bugs.launchpad.net/bugs/851697
Reported-by: David Henningsson <david.henningsson@canonical.com>
Tested-By: Jayne Han <jayne.han@canonical.com>
Cc: stable@kernel.org (3.0)
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When the multi-io jacks are available, parse them first and assign DACs
before parsing speakers and headphones. This allows a better chance of
surround I/O in some desktops and laptops with limited DACs.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The commit 23c09b0090
ALSA: hda - Support multiple speakers by Realtek auto-parser
changes the return value from alc_get_line_out_pfx(), and it breaks
the center/LFE mixer split check. The caller must test with a string
"CLFE" now.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Similarly like ALC662 asus-mode* models, rewrite the laptop-amic and
dmic models with the static pin-config tables.
Now we can get rid of all alc269_quirks.c.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Re-implement the asus-mode[1-8] quirks with the pin-config tables.
They are provided in case where BIOS is broken on the device, so it's
not enabled in PCI SSID lookup table. User needs to specify it via model
option explicitly if the driver doesn't work with the BIOS setup as is.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Let's remove the rest of ALC861 and ALC861-VD quirks.
If any breakage is found, it can be fixed easily via the pin-config
table update.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
During the cleanup by commit 6727b12669,
the specific setups for dallas and hp models, using VREF50 for mic pins,
were lost. Fixed now.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The internal states, jack_present and line_jack_present should be
updated upon unsolicited events even if no automute is set.
Otherwise the wrong state is referred when the automute behavior is
changed by the mixer control.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
When the headphone or speaker output has no own DAC, initialize the path
using the primary DAC. Otherwise the path won't be set properly and
can result in the silence.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Add the support of multiple speakers by Realtek auto-parser.
When all speaker pins have individual DACs, create each speaker volume
control. Otherwise, create a bind-volume control for all speaker outs.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
The new parser may use "PCM" volume, but it was missing the vmaster
slave list, thus "Master" volume didn't control it.
Reference: https://bugzilla.kernel.org/show_bug.cgi?id=41342
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Takashi Iwai
Linus Torvalds
Paul Gortmaker
David Henningsson
Kailang Yang