Don't operate under the assumption that every device that uses the em2820
default USB ID is a Prolink PlayTV USB. We have an eeprom hash, so use that,
since otherwise we cannot support other devices with the 2820 default USB ID
(such as the ADS Tech Instant TV USB USBAV-704)
Signed-off-by: Devin Heitmueller <dheitmueller@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Add the em2870 to the list of known em28xx chip ids.
Signed-off-by: Devin Heitmueller <dheitmueller@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
This cleans-up the advise/acquire methods.
This has been tested on the hvr-1300/4000 and assumed to be
correct on the hvr-3000.
This update also fixes analogue tuning on the hvr-1300
when in blackbird mode.
Signed-off-by: Darron Broad <darron@kewl.org>
Cc: Steven Toth <stoth@hauppauge.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
It has been noticed that in HW tuning mode in cx24123.c that
a check is made to not alter the status var when in one shot
mode, a simpler solution is to not update here for all cards.
Cc: Steven Toth <stoth@hauppauge.com>
Signed-off-by: Darron Broad <darron@kewl.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Delsys was missing when searching for FEC in table.
This fixes FEC lookup for DVB-S2 QPSK modulation.
Cc: Steven Toth <stoth@hauppauge.com>
Signed-off-by: Darron Broad <darron@kewl.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
tuner-xc3028 can be put to sleep to save power. However, if not properly
recovered from sleep, the device won't work. It is noticed that some
devices doesn't recover properly, so let's add a dump_stack() as a debug
option, to allow us to track when this happens.
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Changes/fixes on em28xx dev->lock:
- em28xx_init_dev() were unlocking without a previous lock;
- some read ioctls need to lock after the removal of KBL, since a write
may be happening at the same time an ioctl is reading;
- keep the device locked during all device initialization;
- lock/unlock while reading/writing registers.
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
vidioc_try_fmt_vid_cap() just checks if a given resolution is supported.
It doesn't touch on struct em28xx device descriptor. so, there's no need
to lock.
While there, use unlikely() for those values that aren't likely to
occur.
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Add support for absolute and continuous zoom controls (mapped to absolute
and relative UVC zoom controls).
Signed-off-by: Laurent Pinchart <laurent.pinchart@skynet.be>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Update v4l2_ctrl_get_name() and v4l2_ctrl_get_menu() with missing
control names and menu values.
Signed-off-by: Laurent Pinchart <laurent.pinchart@skynet.be>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
The privacy control prevents video from being acquired by the camera. A true
value indicates that no image can be captured. Devices that implement the
privacy control must support read access and may support write access.
Signed-off-by: Laurent Pinchart <laurent.pinchart@skynet.be>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
The zoom controls move the zoom lens group to a an absolute position, as a
relative displacement or at a given speed until reaching physical device
limits. Positive values move the zoom lens group towards the telephoto
direction, negative values towards the wide-angle direction.
Signed-off-by: Laurent Pinchart <laurent.pinchart@skynet.be>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Refine the firmware load and firmware startup process. Significant changes
are to ensure the SCB and IPC area are correct before starting up the firmware,
and letting the CPU firmware start up the APU firmware for us.
Signed-off-by: Andy Walls <awalls@radix.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
cx18: Use a known open task handle when setting stream CX2341x parameters
Sometimes, we might only have VBI or YUV stream open instead of an MPEG stream.
Let's make sure we use a valid task handle to perform the CX2341x control
settings.
Signed-off-by: Andy Walls <awalls@radix.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
VBI comment corrections to avoid future confusion about standards.
Comments on cx18 VBI implementation shortcomings that need resolution.
Signed-off-by: Andy Walls <awalls@radix.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Removed magic number that referred to firmware limit on the number of
MDLs the firmware can maintain for any stream at any one time.
Signed-off-by: Andy Walls <awalls@radix.net>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Uwe Bugla pointed out that there are some more typos in some print-statements. Fixed.
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
This patch fixes a typo in cx24113.c.
Signed-off-by: Uwe Bugla <uwe.bugla@gmx.de>
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Fixed some minor coding style issues and some driver information
printed when using the driver on a board.
Signed-off-by: Patrick Boettcher <pb@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
The original version of sccb_read_reg() is from Jim Paris.
NOTE: as it is now reading sensor ID won't work for sensors on different
i2c slave address.
Signed-off-by: Antonio Ospite <ospite@studenti.unina.it>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
The vc0321 sends some additional data after sending the complete
frame, we ignore this.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Add support for getting and setting framerate via v4l2 controls,
rather than setting a fixed value at module insertion.
Signed-off-by: Jim Paris <jim@jtan.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Add get_streamparm and set_streamparm operations so subdrivers can
get/set stream parameters such as framerate.
Signed-off-by: Jim Paris <jim@jtan.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Set frame format registers 0x0a and 0x0b to explicit values
rather than relying on reset-time defaults.
Signed-off-by: Jim Paris <jim@jtan.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Frame data in bulk transfers is separated into 2048-byte payloads.
Each payload has its own header.
Signed-off-by: Jim Paris <jim@jtan.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
This sensor was declared as hdcs2020.
The new exchanges have been extracted from the ms-win file usbvm31b.inf.
The light frequency control has been added.
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
This patch moves the last fid and pts from static to the sd structure.
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
The indirect registers at 0x1c/0x1d control frame settings. If we
leave the values at 0x0a and 0x0b at their reset-time defaults, frame
data from the camera matches the UVC payload format. This lets us
better reassemble the data into frames and know when data was lost.
This also lets us relax the bulk_size requirement from 600K to 2K,
which should help systems on with limited RAM (like the PS3).
Signed-off-by: Jim Paris <jim@jtan.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
The frame size is too small, so we lose the last YUYV pixel.
Fix the setup and remove the last_pixel hack.
Signed-off-by: Jim Paris <jim@jtan.com>
Signed-off-by: Jean-Francois Moine <moinejf@free.fr>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>