Put $(LDFLAGS_$(@F)) into ld_flags so that $(LDFLAGS_pcap.o) and
$(LDFLAGS_vde.o) in arch/um/drivers/Makefile are absorbed.
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Acked-by: Kirill A. Shutemov <kirill.shutemov@linux.intel.com>
1. Provides infrastructure for vector IO using recvmmsg/sendmmsg.
1.1. Multi-message read.
1.2. Multi-message write.
1.3. Optimized queue support for multi-packet enqueue/dequeue.
1.4. BQL/DQL support.
2. Implements transports for several transports as well support
for direct wiring of PWEs to NIC. Allows direct connection of VMs
to host, other VMs and network devices with no switch in use.
2.1. Raw socket >4 times higher PPS and 10 times higher tcp RX
than existing pcap based transport (> 4Gbit)
2.2. New tap transport using socket RX and tap xmit. Similar
performance improvements (>4Gbit)
2.3. GRE transport - direct wiring to GRE PWE
2.4. L2TPv3 transport - direct wiring to L2TPv3 PWE
3. Tuning, performance and offload related setting support via ethtool.
4. Initial BPF support - used in tap/raw to avoid software looping
5. Scatter Gather support.
6. VNET and checksum offload support for raw socket transport.
7. TSO/GSO support where applicable or available
8. Migrates all error messages to netdevice_*() and rate limits
them where needed.
Signed-off-by: Anton Ivanov <anton.ivanov@cambridgegreys.com>
Signed-off-by: Richard Weinberger <richard@nod.at>
The ucast transport is similar to the mcast transport (and, in fact,
shares most of its code), only it uses UDP unicast to move packets.
Obviously this is only useful for point-to-point connections between
virtual ethernet devices.
Signed-off-by: Nolan Leake <nolan@cumulusnetworks.com>
Signed-off-by: Richard Weinberger <richard@nod.at>
Cc: David Miller <davem@davemloft.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
we can get DEV_NULL defined for arch/um/drivers/null.c in less
convoluted ways, TYVM...
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
* git://git.kernel.org/pub/scm/linux/kernel/git/sam/kbuild: (40 commits)
kbuild: introduce ccflags-y, asflags-y and ldflags-y
kbuild: enable 'make CPPFLAGS=...' to add additional options to CPP
kbuild: enable use of AFLAGS and CFLAGS on commandline
kbuild: enable 'make AFLAGS=...' to add additional options to AS
kbuild: fix AFLAGS use in h8300 and m68knommu
kbuild: check for wrong use of CFLAGS
kbuild: enable 'make CFLAGS=...' to add additional options to CC
kbuild: fix up CFLAGS usage
kbuild: make modpost detect unterminated device id lists
kbuild: call export_report from the Makefile
kbuild: move Kai Germaschewski to CREDITS
kconfig/menuconfig: distinguish between selected-by-another options and comments
kconfig: tristate choices with mixed tristate and boolean values
include/linux/Kbuild: remove duplicate entries
kbuild: kill backward compatibility checks
kbuild: kill EXTRA_ARFLAGS
kbuild: fix documentation in makefiles.txt
kbuild: call make once for all targets when O=.. is used
kbuild: pass -g to assembler under CONFIG_DEBUG_INFO
kbuild: update _shipped files for kconfig syntax cleanup
...
Fix up conflicts in arch/um/sys-{x86_64,i386}/Makefile manually.
The variable CFLAGS is a wellknown variable and the usage by
kbuild may result in unexpected behaviour.
On top of that several people over time has asked for a way to
pass in additional flags to gcc.
This patch replace use of CFLAGS with KBUILD_CFLAGS all over the
tree and enabling one to use:
make CFLAGS=...
to specify additional gcc commandline options.
One usecase is when trying to find gcc bugs but other
use cases has been requested too.
Patch was tested on following architectures:
alpha, arm, i386, x86_64, mips, sparc, sparc64, ia64, m68k
Test was simple to do a defconfig build, apply the patch and check
that nothing got rebuild.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
The patch to use host AIO support that I submitted early after 2.6.13 exposed
some problems in the block driver. I have fixes for these, but am not
comfortable putting them into 2.6.14 at this late date. So, this patch reverts
the use of host AIO.
I will resubmit the original patch, plus fixes to the driver after 2.6.14
in order to get a reasonable amount of testing before they're exposed to
the general public.
Signed-off-by: Jeff Dike <jdike@addtoit.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This adds AIO support to the ubd driver.
The driver breaks a struct request into IO requests to the host, based on the
hardware segments in the request and on any COW blocks covered by the request.
The ubd IO thread is gone, since there is now an equivalent thread in the AIO
module.
There is provision for multiple outstanding requests now. Requests aren't
retired until all pieces of it have been completed. The AIO requests have a
shared count, which is decremented as IO operations come in until it reaches
0. This can be possibly moved to the request struct - haven't looked at this
yet.
Signed-off-by: Jeff Dike <jdike@addtoit.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Just a Kbuild subtlety, not listing a target file inside targets causes it
to be rebuilt each time, and as a consequence everything depending on it is
rebuilt.
Signed-off-by: Paolo 'Blaisorblade' Giarrusso <blaisorblade@yahoo.it>
Cc: Jeff Dike <jdike@addtoit.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
The pcap support was not working because of some linking problems (expressing
the construct in Kbuild was a bit difficult) and because there was no user
request. Now that this has come back, here's the support.
This has been tested and works on both 32 and 64-bit hosts, even when
"cross-"building 32-bit binaries.
Signed-off-by: Paolo 'Blaisorblade' Giarrusso <blaisorblade@yahoo.it>
Cc: Jeff Dike <jdike@addtoit.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This patch merges a lot of duplicated code in the slip and slirp drivers,
abstracts out the slip protocol, and makes the slip driver work in 2.6.
Signed-off-by: Jeff Dike <jdike@addtoit.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
Masahiro Yamada
Anton Ivanov
Nolan Leake
Al Viro
Linus Torvalds
Jeff Dike
Sam Ravnborg
Paolo 'Blaisorblade' Giarrusso
Linus Torvalds