Allocate a large buffer for each OCC to handle response data. This
removes memory allocation during an operation, and also allows for
the maximum amount of SBE FFDC.
Previously for the putsram and attn commands, only 32 words would have
been available, and for getsram, only up to the size of the transfer.
SBE FFDC might be up to 8Kb.
The SBE interface expects data to be specified in units of words (4
bytes), defined as OCC_MAX_RESP_WORDS.
This change allows the full FFDC capture to be implemented, where before
it was not available.
Signed-off-by: Eddie James <eajames@linux.ibm.com>
Link: https://lore.kernel.org/r/20211019205307.36946-2-eajames@linux.ibm.com
Signed-off-by: Joel Stanley <joel@jms.id.au>
The OCC is a device embedded on a POWER processor that collects and
aggregates sensor data from the processor and system. The OCC can
provide the raw sensor data as well as perform thermal and power
management on the system.
This driver provides an atomic communications channel between a service
processor (e.g. a BMC) and the OCC. The driver is dependent on the FSI
SBEFIFO driver to get hardware access through the SBE to the OCC SRAM.
Commands are issued to the SBE to send or fetch data to the SRAM.
Signed-off-by: Eddie James <eajames@linux.ibm.com>
Signed-off-by: Andrew Jeffery <andrew@aj.id.au>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: Joel Stanley <joel@jms.id.au>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
Eddie James
Eddie James