The immediate benefit of doing this is that on NV50 and up, the GPU
virtual address of any buffer is now constant, regardless of what
memtype they're placed in.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This adds a table of known nvc0 memtypes, and modifies the validity check
to allow any non-compressed type. Support for Z compression will come at
a later point.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Upcoming patches are going to enable full support for buffers that keep
a constant GPU virtual address whenever they're validated for use by
the GPU.
In order for this to work properly while keeping support for large pages,
we need to know if it's ever going to be possible for a buffer to end
up in GART, and if so, disable large pages for the buffer's VMA.
This is a new restriction that's not present in earlier kernel's, but
should not break userspace as the current code never attempts to validate
buffers into a memtype other than it was created with.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
'mappable' isn't really used at all, nor is it necessary anymore as the
bo code is capable of moving buffers to mappable vram as required.
'no_vm' isn't necessary anymore either, any places that don't want to be
mapped into a GPU address space should allocate the VRAM directly instead.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The code was supposed to print registers around 0x405018 (which is read
earlier), not 0x405818.
Signed-off-by: Marcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The hw doesn't really appear to be designed to be used the way we have to
use it due to DRI2's design. This leads us to having to keep the flipped
fb support active at all times.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
Also imports a couple of helper functions that'll be used to implement
page flipping in the following commits..
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This should prevent a number of races from occuring, the most obvious of
which will be exposed when we start making use of the "display sync" evo
channel for page flipping. The DS channel will reject any command stream
that doesn't completely agree with the current "master" state.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
We need to be able to have the bh run while possibly spinning waiting for
the EVO notifier to signal. This apparently happens in some circumstances
with preempt disabled, so our workqueue was never being run.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
The nv50 display isr bh needs to be converted to a tasklet, which means
we can't sleep anymore. The places we execute vbios init tables are
rare, and not in any way performance critical, so this isn't a huge
problem.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
With cmwq, there's no reason for nouveau to use a dedicated workqueue.
Drop dev_priv->wq and use system_wq instead. Each work item is sync
flushed when the containing structure is unregistered/destroyed.
Note that this change also makes sure that nv50_gpio_handler is not
freed while the contained work item is still running.
Signed-off-by: Tejun Heo <tj@kernel.org>
Cc: David Airlie <airlied@linux.ie>
Cc: dri-devel@lists.freedesktop.org
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This gives a small, but noticeable performance gain at lower performance
levels, and unchanged at the higher ones.
With this commit, we're now using the same timeslice size as the NVIDIA
binary driver currently does, and dropping an unknown bit that NVIDIA
no longer appear to set.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
We may well be making more use of semaphores in the future, having the
entire VM available makes requiring DMA objects for each and every
semaphore block unnecessary.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
And also, don't disable PFIFO IRQs completely whenever we recieve one,
just when we don't know about it already.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
These are the same semaphores nvc0 will use, and they potentially allow
us to do much cooler things than our current inter-channel sync impl.
Lets switch to them where possible now for some testing.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
In preparation for the addition of a new nv40 backend, we'll need to be
able to distinguish between a paged dma object and the on-chip GART.
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>
This reverts commit 5a893fc28f.
This causes a use after free in the ttm free alloc pages path,
when it tries to get the be after the be has been destroyed.
Signed-off-by: Dave Airlie <airlied@redhat.com>
* 'stable/ttm.pci-api.v5' of git://git.kernel.org/pub/scm/linux/kernel/git/konrad/xen:
ttm: Include the 'struct dev' when using the DMA API.
nouveau/ttm/PCIe: Use dma_addr if TTM has set it.
radeon/ttm/PCIe: Use dma_addr if TTM has set it.
ttm: Expand (*populate) to support an array of DMA addresses.
ttm: Utilize the DMA API for pages that have TTM_PAGE_FLAG_DMA32 set.
ttm: Introduce a placeholder for DMA (bus) addresses.
Using an order 19 drm_ht for the mmap offsets is a little obscene. That
means that will a fully populated GTT with every single object mmaped at
least once in its lifetime, there will be exactly one object in each
bucket.
Typically systems only have at most a few thousand objects, though you
may see a KDE desktop hit 50000. And most of those should never be
mapped... On my systems, just using an order 10 ht would still have an
average occupancy less than 1, so apply a small safety factor and
use an order 12 ht, like the other mmap offset ht.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Signed-off-by: Dave Airlie <airlied@redhat.com>
... and fixup some methods to accept the constant argument.
Now that constant module arrays are loaded into read-only memory, using
const appropriately has some benefits beyond warning the programmer
about likely mistakes.
Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
Signed-off-by: Dave Airlie <airlied@redhat.com>
the texture checking code didn't work for block formats like s3tc,
this overhauls it to work for all types.
v2: add texture array support.
v3: add subsampled formats
Signed-off-by: Dave Airlie <airlied@redhat.com>
Ben Skeggs
Benjamin Franzke
Marcin Slusarz
Tejun Heo
Lucas Stach
Dave Airlie
Chris Wilson