Граф коммитов

6 Коммитов

Автор SHA1 Сообщение Дата
Wolfram Sang 1e4f0b8257 i2c: mxs: disable QUEUE when sending is done
Since the last fixes to this driver ensure now the queue termination is
done correctly, we can finally disable the queue after a transfer
without problems. The gain is that it will only be reenabled after the
next transfer is fully set up. Before, the queue was running all the
time and if the setup of the next message was interrupted by another
thread, an incomplete buffer could have been sent, padded with zeroes.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
2012-04-27 16:13:29 +02:00
Wolfram Sang c95eeae9e3 i2c: mxs: handle spurious interrupt
After an error interrupt setting cmd->err, I see another interrupt that
the data engine is empty which clears cmd->err before being processed.
So, clear cmd->err at the beginning of a transfer only to handle these
consecutive interrupts.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
2012-04-25 22:59:44 +02:00
Wolfram Sang 844990daa2 i2c: mxs: only flag completion when queue is completely done
The hardware generates an interrupt for every completed command in the
queue while the code assumed that it will only generate one interrupt
when the queue is empty. So, explicitly check if the queue is really
empty. This patch fixed problems which occurred due to high traffic on
the bus. While we are here, move the completion-initialization after the
parameter error checking.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Cc: Shawn Guo <shawn.guo@linaro.org>
Cc: Marek Vasut <marek.vasut@gmail.com>
Cc: Lothar Waßmann <LW@KARO-electronics.de>
Cc: stable@kernel.org
2012-02-24 22:28:27 +01:00
Lucas De Marchi 25985edced Fix common misspellings
Fixes generated by 'codespell' and manually reviewed.

Signed-off-by: Lucas De Marchi <lucas.demarchi@profusion.mobi>
2011-03-31 11:26:23 -03:00
Sascha Hauer 6b7d815c3f i2c-mxs: set controller to pio queue mode after reset
mxs_reset_block() clears the PIO_QUEUE_MODE bit. So we have
to set it again after a controller reset.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Cc: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
2011-03-20 23:54:52 +00:00
Wolfram Sang a8da7fecb6 i2c: add driver for Freescale i.MX28
Currently only supporting the PIOQUEUE-mode, because DMA-support for
this platform is not yet in mainline. When it becomes available and
support has been added to this driver, it will also be suitable for
i.MX23 and STMP3xxx.

Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
Cc: Ben Dooks <ben-linux@fluff.org>
Cc: Shawn Guo <shawn.guo@freescale.com>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
2011-02-23 01:00:11 +00:00