Граф коммитов

10 Коммитов

Автор SHA1 Сообщение Дата
Frank Li 2cf2581cd2
usb: cdns3: add power lost support for system resume
If the controller lost its power during the system suspend, we need
to do all initialiation operations.

Signed-off-by: Peter Chen <peter.chen@nxp.com>
Signed-off-by: Frank Li <frank.li@nxp.com>
Signed-off-by: Peter Chen <peter.chen@kernel.org>
2021-04-12 20:19:20 +08:00
Pawel Laszczak 3d82904559
usb: cdnsp: cdns3 Add main part of Cadence USBSSP DRD Driver
This patch introduces the main part of Cadence USBSSP DRD driver
to Linux kernel.
To reduce the patch size a little bit, the header file gadget.h was
intentionally added as separate patch.

The Cadence USBSSP DRD Controller is a highly configurable IP Core which
can be instantiated as Dual-Role Device (DRD), Peripheral Only and
Host Only (XHCI)configurations.

The current driver has been validated with FPGA platform. We have
support for PCIe bus, which is used on FPGA prototyping.

The host side of USBSS DRD controller is compliant with XHCI.
The architecture for device side is almost the same as for host side,
and most of the XHCI specification can be used to understand how
this controller operates.

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Signed-off-by: Peter Chen <peter.chen@nxp.com>
2020-12-29 12:36:13 +08:00
Pawel Laszczak 0b490046d8
usb: cdns3: Refactoring names in reusable code
Patch change the functions and objects names in reusable code.
The reusable code includes core.c, core.h, drd.c and drd.h files.
It also changes the names of all references to these functions and
objects in other cdns3 files. There are a lot of changes, but all
changes are very trivial.
The reason of this patch is to avoid of mixing prefix cdns3 and cdnsp in
in cdnsp driver what could introduce some confusion in understanding
of cdnsp driver.
This patch assumes to use three different prefixes in Cadence
USB drivers:
  cdns: for common reusable code
  cdnsp: for names related only with cdnsp driver
  cdns3: for names related only with cdns3 driver

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Tested-by: Aswath Govindraju <a-govindraju@ti.com>
Signed-off-by: Peter Chen <peter.chen@nxp.com>
2020-12-29 12:36:13 +08:00
Pawel Laszczak f738957277
usb: cdns3: Split core.c into cdns3-plat and core.c file
Patch splits file core.c into core.c containing the common reusable code
and cnd3-plat.c containing device platform specific code. These changes
are required to make possible reuse DRD part of CDNS3 driver in CDNSP
driver.

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Tested-by: Aswath Govindraju <a-govindraju@ti.com>
Signed-off-by: Peter Chen <peter.chen@nxp.com>
2020-12-29 12:36:13 +08:00
Pawel Laszczak db8892bb1b
usb: cdns3: Add support for DRD CDNSP
Patch adds support for Cadence DRD Super Speed Plus controller(CDNSP).
CDNSP DRD is a part of Cadence CDNSP controller.
The DRD CDNSP controller has a lot of difference on hardware level but on
software level is quite compatible with CDNS3 DRD. For this reason
CDNS3 DRD part of CDNS3 driver was reused for CDNSP driver.

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Tested-by: Aswath Govindraju <a-govindraju@ti.com>
Signed-off-by: Peter Chen <peter.chen@nxp.com>
2020-12-29 12:36:13 +08:00
Pawel Laszczak 2eae2dfd58 usb: cdns3: Enable workaround for USB2.0 PHY Rx compliance test PHY lockup
USB2.0 PHY hangs in Rx Compliance test when the incoming packet
amplitude is varied below and above the Squelch Level of
Receiver during the active packet multiple times.

Version 1 of the controller allows PHY to be reset when RX fail condition
is detected to work around the above issue. This feature is
disabled by default and needs to be enabled using a bit from
the newly added PHYRST_CFG register. This patch enables the workaround.

There is no way to know controller version before device controller
is started and the workaround needs to be applied for both host and
device modes, so we rely on a DT property do decide when to
apply the workaround.

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Felipe Balbi <balbi@kernel.org>
2020-10-02 09:57:39 +03:00
Pawel Laszczak b2aeb6da3d usb: cdns3: drd: simplify *switch_gadet and *switch_host
Patch split function cdns3_drd_switch_gadget and
cdns3_drd_switch_host into:
- cdns3_drd_host_on
- cdns3_drd_host_off
- cdns3_drd_gadget_on
- cdns3_drd_gadgett_off

These functions don't have any shared code so it's better to
have smaller, faster and easier functions.

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Reviewed-by: Peter Chen <peter.chen@nxp.com>
Signed-off-by: Felipe Balbi <balbi@kernel.org>
2020-07-24 16:45:13 +03:00
Pawel Laszczak 08c35dd3cc usb: cdns3: Added CDNS3_ID_PERIPHERAL and CDNS3_ID_HOST
Patch adds 2 definitions that make it easier to understand the code.

Reviewed-by: Peter Chen <peter.chen@nxp.com>
Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Signed-off-by: Felipe Balbi <balbi@kernel.org>
2020-07-24 16:45:13 +03:00
Pawel Laszczak 245258495a usb: cdns3: drd: changed return type from int to bool
Patch changes return type from int to bool for
cdns3_is_host and cdns3_is_device functions.

Reviewed-by: Peter Chen <peter.chen@nxp.com>
Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Signed-off-by: Felipe Balbi <balbi@kernel.org>
2020-07-24 16:45:13 +03:00
Pawel Laszczak 7733f6c32e usb: cdns3: Add Cadence USB3 DRD Driver
This patch introduce new Cadence USBSS DRD driver to Linux kernel.

The Cadence USBSS DRD Controller is a highly configurable IP Core which
can be instantiated as Dual-Role Device (DRD), Peripheral Only and
Host Only (XHCI)configurations.

The current driver has been validated with FPGA platform. We have
support for PCIe bus, which is used on FPGA prototyping.

The host side of USBSS-DRD controller is compliant with XHCI
specification, so it works with standard XHCI Linux driver.

Signed-off-by: Pawel Laszczak <pawell@cadence.com>
Signed-off-by: Felipe Balbi <felipe.balbi@linux.intel.com>
2019-08-29 10:57:04 +03:00