Граф коммитов

5 Коммитов

Автор SHA1 Сообщение Дата
Mark Fasheh 9c7af40b21 ocfs2: throttle back local alloc when low on disk space
Ocfs2's local allocator disables itself for the duration of a mount point
when it has trouble allocating a large enough area from the primary bitmap.
That can cause performance problems, especially for disks which were only
temporarily full or fragmented. This patch allows for the allocator to
shrink it's window first, before being disabled. Later, it can also be
re-enabled so that any performance drop is minimized.

To do this, we allow the value of osb->local_alloc_bits to be shrunk when
needed. The default value is recorded in a mostly read-only variable so that
we can re-initialize when required.

Locking had to be updated so that we could protect changes to
local_alloc_bits. Mostly this involves protecting various local alloc values
with the osb spinlock. A new state is also added, OCFS2_LA_THROTTLED, which
is used when the local allocator is has shrunk, but is not disabled. If the
available space dips below 1 megabyte, the local alloc file is disabled. In
either case, local alloc is re-enabled 30 seconds after the event, or when
an appropriate amount of bits is seen in the primary bitmap.

Signed-off-by: Mark Fasheh <mfasheh@suse.com>
2008-10-13 13:57:57 -07:00
Mark Fasheh 415cb80037 ocfs2: Allow smaller allocations during large writes
The ocfs2 write code loops through a page much like the block code, except
that ocfs2 allocation units can be any size, including larger than page
size. Typically it's equal to or larger than page size - most kernels run 4k
pages, the minimum ocfs2 allocation (cluster) size.

Some changes introduced during 2.6.23 changed the way writes to pages are
handled, and inadvertantly broke support for > 4k page size. Instead of just
writing one cluster at a time, we now handle the whole page in one pass.

This means that multiple (small) seperate allocations might happen in the
same pass. The allocation code howver typically optimizes by getting the
maximum which was reserved. This triggered a BUG_ON in the extend code where
it'd ask for a single bit (for one part of a > 4k page) and get back more
than it asked for.

Fix this by providing a variant of the high level allocation function which
allows the caller to specify a maximum. The traditional function remains and
just calls the new one with a maximum determined from the initial
reservation.

Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
2007-09-20 15:06:09 -07:00
Mark Fasheh 1fabe1481f ocfs2: Remove struct ocfs2_journal_handle in favor of handle_t
This is mostly a search and replace as ocfs2_journal_handle is now no more
than a container for a handle_t pointer.

ocfs2_commit_trans() becomes very straight forward, and we remove some out
of date comments / code.

Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
2006-12-01 18:28:28 -08:00
Mark Fasheh da5cbf2f9d ocfs2: don't use handle for locking in allocation functions
Instead we record our state on the allocation context structure which all
callers already know about and lifetime correctly. This means the
reservation functions don't need a handle passed in any more, and we can
also take it off the alloc context.

Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
2006-12-01 18:27:49 -08:00
Mark Fasheh ccd979bdbc [PATCH] OCFS2: The Second Oracle Cluster Filesystem
The OCFS2 file system module.

Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
Signed-off-by: Kurt Hackel <kurt.hackel@oracle.com>
2006-01-03 11:45:47 -08:00