WSL2-Linux-Kernel/arch/mips/bcm47xx
Linus Torvalds d9862cfbe2 Here's the main MIPS pull request for v5.1:
- Support for the MIPSr6 MemoryMapID register & Global INValidate TLB
   (GINVT) instructions, allowing for more efficient TLB maintenance when
   running on a CPU such as the I6500 that supports these.
 
 - Enable huge page support for MIPS64r6.
 
 - Optimize post-DMA cache sync by removing that code entirely for kernel
   configurations in which we know it won't be needed.
 
 - The number of pages allocated for interrupt stacks is now calculated
   correctly, where before we would wastefully allocate too much memory
   in some configurations.
 
 - The ath79 platform migrates to devicetree.
 
 - The bcm47xx platform sees fixes for the Buffalo WHR-G54S board.
 
 - The ingenic/jz4740 platform gains support for appended devicetrees.
 
 - The cavium_octeon, lantiq, loongson32 & sgi-ip27 platforms all see
   cleanups as do various pieces of core architecture code.
 -----BEGIN PGP SIGNATURE-----
 
 iIsEABYIADMWIQRgLjeFAZEXQzy86/s+p5+stXUA3QUCXH3BQxUccGF1bC5idXJ0
 b25AbWlwcy5jb20ACgkQPqefrLV1AN1+4wD+Oh4JTfZN/NEOQMlrSkXxjEHqjX3u
 1Y6CiiPCs+q2UnYBANb+ic+ZH5MnvJxxmcvlYI2q3rIh4b8TDriip4KMUTUP
 =Sw9X
 -----END PGP SIGNATURE-----

Merge tag 'mips_5.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux

Pull MIPS updates from Paul Burton:

 - Support for the MIPSr6 MemoryMapID register & Global INValidate TLB
   (GINVT) instructions, allowing for more efficient TLB maintenance
   when running on a CPU such as the I6500 that supports these.

 - Enable huge page support for MIPS64r6.

 - Optimize post-DMA cache sync by removing that code entirely for
   kernel configurations in which we know it won't be needed.

 - The number of pages allocated for interrupt stacks is now calculated
   correctly, where before we would wastefully allocate too much memory
   in some configurations.

 - The ath79 platform migrates to devicetree.

 - The bcm47xx platform sees fixes for the Buffalo WHR-G54S board.

 - The ingenic/jz4740 platform gains support for appended devicetrees.

 - The cavium_octeon, lantiq, loongson32 & sgi-ip27 platforms all see
   cleanups as do various pieces of core architecture code.

* tag 'mips_5.1' of git://git.kernel.org/pub/scm/linux/kernel/git/mips/linux: (66 commits)
  MIPS: lantiq: Remove separate GPHY Firmware loader
  MIPS: ingenic: Add support for appended devicetree
  MIPS: SGI-IP27: rework HUB interrupts
  MIPS: SGI-IP27: do boot CPU init later
  MIPS: SGI-IP27: do xtalk scanning later
  MIPS: SGI-IP27: use pr_info/pr_emerg and pr_cont to fix output
  MIPS: SGI-IP27: clean up bridge access and header files
  MIPS: SGI-IP27: get rid of volatile and hubreg_t
  MIPS: irq: Allocate accurate order pages for irq stack
  MIPS: dma-noncoherent: Remove bogus condition in dma_sync_phys()
  MIPS: eBPF: Remove REG_32BIT_ZERO_EX
  MIPS: eBPF: Always return sign extended 32b values
  MIPS: CM: Fix indentation
  MIPS: BCM47XX: Fix/improve Buffalo WHR-G54S support
  MIPS: OCTEON: program rx/tx-delay always from DT
  MIPS: OCTEON: delete board-specific link status
  MIPS: OCTEON: don't lie about interface type of CN3005 board
  MIPS: OCTEON: warn if deprecated link status is being used
  MIPS: OCTEON: add fixed-link nodes to in-kernel device tree
  MIPS: Delete unused flush_cache_sigtramp()
  ...
2019-03-05 11:28:25 -08:00
..
Kconfig License cleanup: add SPDX GPL-2.0 license identifier to files with no license 2017-11-02 11:10:55 +01:00
Makefile MIPS: BCM47xx: Move SPROM driver to drivers/firmware/ 2016-05-13 14:01:43 +02:00
Platform MIPS: bcm47xx: enable ZBOOT support 2018-01-24 11:20:29 +00:00
bcm47xx_private.h License cleanup: add SPDX GPL-2.0 license identifier to files with no license 2017-11-02 11:10:55 +01:00
board.c MIPS: BCM47XX: Add support for Netgear WNR1000 V3 2018-04-23 16:39:34 +01:00
buttons.c MIPS: BCM47XX: Fix/improve Buffalo WHR-G54S support 2019-02-11 13:29:33 -08:00
irq.c MIPS: BCM47XX: Initialize bcma bus later (with mm available) 2014-11-24 07:45:00 +01:00
leds.c MIPS: BCM47XX: Fix/improve Buffalo WHR-G54S support 2019-02-11 13:29:33 -08:00
prom.c MIPS: BCM77xx: Remove legacy __cpuinit{,data} sections that crept in 2015-06-21 21:53:42 +02:00
serial.c MIPS: BCM47xx: Make serial explicitly non-modular 2016-10-04 16:13:57 +02:00
setup.c net: phy: fixed-phy: Drop GPIO from fixed_phy_add() 2019-02-04 18:33:36 -08:00
time.c MIPS: BCM47XX: Fix coding style to match kernel standards 2015-04-01 17:22:10 +02:00
workarounds.c MIPS: BCM47XX: Enable USB power on Netgear WNDR3400v3 2018-08-29 11:11:00 -07:00