34 строки
1.2 KiB
Plaintext
34 строки
1.2 KiB
Plaintext
* Atmel SDHCI controller
|
|
|
|
This file documents the differences between the core properties in
|
|
Documentation/devicetree/bindings/mmc/mmc.txt and the properties used by the
|
|
sdhci-of-at91 driver.
|
|
|
|
Required properties:
|
|
- compatible: Must be "atmel,sama5d2-sdhci" or "microchip,sam9x60-sdhci".
|
|
- clocks: Phandlers to the clocks.
|
|
- clock-names: Must be "hclock", "multclk", "baseclk" for
|
|
"atmel,sama5d2-sdhci".
|
|
Must be "hclock", "multclk" for "microchip,sam9x60-sdhci".
|
|
|
|
Optional properties:
|
|
- assigned-clocks: The same with "multclk".
|
|
- assigned-clock-rates The rate of "multclk" in order to not rely on the
|
|
gck configuration set by previous components.
|
|
- microchip,sdcal-inverted: when present, polarity on the SDCAL SoC pin is
|
|
inverted. The default polarity for this signal is described in the datasheet.
|
|
For instance on SAMA5D2, the pin is usually tied to the GND with a resistor
|
|
and a capacitor (see "SDMMC I/O Calibration" chapter).
|
|
|
|
Example:
|
|
|
|
mmc0: sdio-host@a0000000 {
|
|
compatible = "atmel,sama5d2-sdhci";
|
|
reg = <0xa0000000 0x300>;
|
|
interrupts = <31 IRQ_TYPE_LEVEL_HIGH 0>;
|
|
clocks = <&sdmmc0_hclk>, <&sdmmc0_gclk>, <&main>;
|
|
clock-names = "hclock", "multclk", "baseclk";
|
|
assigned-clocks = <&sdmmc0_gclk>;
|
|
assigned-clock-rates = <480000000>;
|
|
};
|