There are 2 ways in which a DSA user port may become handled by 2 CPU
ports in a LAG:
(1) its current DSA master joins a LAG
ip link del bond0 && ip link add bond0 type bond mode 802.3ad
ip link set eno2 master bond0
When this happens, all user ports with "eno2" as DSA master get
automatically migrated to "bond0" as DSA master.
(2) it is explicitly configured as such by the user
# Before, the DSA master was eno3
ip link set swp0 type dsa master bond0
The design of this configuration is that the LAG device dynamically
becomes a DSA master through dsa_master_setup() when the first physical
DSA master becomes a LAG slave, and stops being so through
dsa_master_teardown() when the last physical DSA master leaves.
A LAG interface is considered as a valid DSA master only if it contains
existing DSA masters, and no other lower interfaces. Therefore, we
mainly rely on method (1) to enter this configuration.
Each physical DSA master (LAG slave) retains its dev->dsa_ptr for when
it becomes a standalone DSA master again. But the LAG master also has a
dev->dsa_ptr, and this is actually duplicated from one of the physical
LAG slaves, and therefore needs to be balanced when LAG slaves come and
go.
To the switch driver, putting DSA masters in a LAG is seen as putting
their associated CPU ports in a LAG.
We need to prepare cross-chip host FDB notifiers for CPU ports in a LAG,
by calling the driver's ->lag_fdb_add method rather than ->port_fdb_add.
Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
acc43b7bf5