WSL2-Linux-Kernel/drivers/mmc
Linus Torvalds dfabb077d6 MMC core:
- Add support for host software queue for (e)MMC/SD
  - Throttle polling rate for CMD6
  - Update CMD13 busy condition check for CMD6 commands
  - Improve busy detect polling for erase/trim/discard/HPI
  - Fixup support for HW busy detection for HPI commands
  - Re-work and improve support for eMMC sanitize commands
 
 MMC host:
  - mmci: Add support for sdmmc variant revision 2.0
  - mmci_sdmmc: Improve support for busyend detection
  - mmci_sdmmc: Fixup support for signal voltage switch
  - mmci_sdmmc: Add support for tuning with delay block
  - mtk-sd: Fix another SDIO irq issue
  - sdhci: Disable native card detect when GPIO based type exist
  - sdhci: Add option to defer request completion
  - sdhci_am654: Add support to set a tap value per speed mode
  - sdhci-esdhc-imx: Add support for i.MX8MM based variant
  - sdhci-esdhc-imx: Fixup support for standard tuning on i.MX8 usdhc
  - sdhci-esdhc-imx: Optimize for strobe/clock dll settings
  - sdhci-esdhc-imx: Fixup support for system and runtime suspend/resume
  - sdhci-iproc: Update regulator/bus-voltage management for bcm2711
  - sdhci-msm: Prevent clock gating with PWRSAVE_DLL on broken variants
  - sdhci-msm: Fix management of CQE during SDHCI reset
  - sdhci-of-arasan: Add support for auto tuning on ZynqMP based platforms
  - sdhci-omap: Add support for system suspend/resume
  - sdhci-sprd: Add support for HW busy detection
  - sdhci-sprd: Enable support host software queue
  - sdhci-tegra: Add support for HW busy detection
  - tmio/renesas_sdhi: Enforce retune after runtime suspend
  - renesas_sdhi: Use manual tap correction for HS400 on some variants
  - renesas_sdhi: Add support for manual correction of tap values for tunings
 -----BEGIN PGP SIGNATURE-----
 
 iQJLBAABCgA1FiEEugLDXPmKSktSkQsV/iaEJXNYjCkFAl6CGT8XHHVsZi5oYW5z
 c29uQGxpbmFyby5vcmcACgkQ/iaEJXNYjClFWg/+LzX09vHBOfAu7hT/RokcTaBT
 uQnSAfmhkBI+CZerVulPjDX9lFpG2Jb/fu44Ae9EqOAOESAgsTJpxywRRO2f+aNL
 ie9mc0WOkmz1wuAbqYPJImES0CIL2WNpivovLgquRWyltbneh+ImkCbqoWmDYff7
 uIuIC4EPhrWYJczdKr5RCw6HVbsNEAgAr6oJEbmzC63HciCPx5Zo99FN5WHoyRnf
 3c3Ehc4wkVy5iu/wlXqmRdvuayDHhAAmVq6FP5J3IfuoeES3EYeKHc2Ej+pwhYi9
 IFCrO8RDKEu3/o5hLp60ShhF7N/LGWYsl+5KfrwOQ6YPyMLYawR6L0iTYSqkQijy
 3admTGD4OGFuN/8DvQb0yUwhSpRm/Dj+jBZTP3uk9FJHteFlLNHnzREk7weo8i/R
 2WNDSbbV3+TudfC0uC4ipsHtDoidyds+TvR/ebO53pH2Dcr/z6h7i+1tKczA2rK4
 x9mqXhOsskNZC26/UBb9K2oElRON4XDv+VZdQI5ddDuabIYIswXMWLYD1TGYoX5z
 1PXSrrj/Jl/Sz65ZpabKJOexa24s2uThvpOnrGCy2aDc/tbDpcvVhKwL6NX9iRK0
 yYKpwy9yWCGMryVfLI+ahJpvJfQDY4ufKpLC2429LVvgFvNZDG233ZcZhdlhoLNG
 nWh9qHTGTPWo/213yx0=
 =gILc
 -----END PGP SIGNATURE-----

Merge tag 'mmc-v5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc

Pull MMC updates from Ulf Hansson:
 "MMC core:
   - Add support for host software queue for (e)MMC/SD
   - Throttle polling rate for CMD6
   - Update CMD13 busy condition check for CMD6 commands
   - Improve busy detect polling for erase/trim/discard/HPI
   - Fixup support for HW busy detection for HPI commands
   - Re-work and improve support for eMMC sanitize commands

  MMC host:
   - mmci:
       * Add support for sdmmc variant revision 2.0
   - mmci_sdmmc:
       * Improve support for busyend detection
       * Fixup support for signal voltage switch
       * Add support for tuning with delay block
   - mtk-sd:
       * Fix another SDIO irq issue
   - sdhci:
       * Disable native card detect when GPIO based type exist
   - sdhci:
       * Add option to defer request completion
   - sdhci_am654:
       * Add support to set a tap value per speed mode
   - sdhci-esdhc-imx:
       * Add support for i.MX8MM based variant
       * Fixup support for standard tuning on i.MX8 usdhc
       * Optimize for strobe/clock dll settings
       * Fixup support for system and runtime suspend/resume
   - sdhci-iproc:
       * Update regulator/bus-voltage management for bcm2711
   - sdhci-msm:
       * Prevent clock gating with PWRSAVE_DLL on broken variants
       * Fix management of CQE during SDHCI reset
   - sdhci-of-arasan:
       * Add support for auto tuning on ZynqMP based platforms
   - sdhci-omap:
       * Add support for system suspend/resume
   - sdhci-sprd:
       * Add support for HW busy detection
       * Enable support host software queue
   - sdhci-tegra:
       * Add support for HW busy detection
   - tmio/renesas_sdhi:
       * Enforce retune after runtime suspend
   - renesas_sdhi:
       * Use manual tap correction for HS400 on some variants
       * Add support for manual correction of tap values for tunings"

* tag 'mmc-v5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc: (86 commits)
  mmc: cavium-octeon: remove nonsense variable coercion
  mmc: mediatek: fix SDIO irq issue
  mmc: mmci_sdmmc: Fix clear busyd0end irq flag
  dt-bindings: mmc: Fix node name in an example
  mmc: core: Re-work the code for eMMC sanitize
  mmc: sdhci: use FIELD_GET for preset value bit masks
  mmc: sdhci-of-at91: Display clock changes for debug purpose only
  mmc: sdhci: iproc: Add custom set_power() callback for bcm2711
  mmc: sdhci: am654: Use sdhci_set_power_and_voltage()
  mmc: sdhci: at91: Use sdhci_set_power_and_voltage()
  mmc: sdhci: milbeaut: Use sdhci_set_power_and_voltage()
  mmc: sdhci: arasan: Use sdhci_set_power_and_voltage()
  mmc: sdhci: Introduce sdhci_set_power_and_bus_voltage()
  mmc: vub300: Use scnprintf() for avoiding potential buffer overflow
  dt-bindings: mmc: synopsys-dw-mshc: fix clock-freq-min-max in example
  sdhci: tegra: Enable MMC_CAP_WAIT_WHILE_BUSY host capability
  sdhci: tegra: Implement Tegra specific set_timeout callback
  mmc: sdhci-omap: Add Support for Suspend/Resume
  mmc: renesas_sdhi: simplify execute_tuning
  mmc: renesas_sdhi: Use BITS_PER_LONG helper
  ...
2020-03-31 16:13:09 -07:00
..
core mmc: core: Re-work the code for eMMC sanitize 2020-03-26 14:45:31 +01:00
host MMC core: 2020-03-31 16:13:09 -07:00
Kconfig treewide: Add SPDX license identifier - Makefile/Kconfig 2019-05-21 10:50:46 +02:00
Makefile treewide: Add SPDX license identifier - Makefile/Kconfig 2019-05-21 10:50:46 +02:00