WSL2-Linux-Kernel/Documentation/devicetree/bindings/net/phy.txt

41 строка
1.5 KiB
Plaintext

PHY nodes
Required properties:
- interrupts : <a b> where a is the interrupt number and b is a
field that represents an encoding of the sense and level
information for the interrupt. This should be encoded based on
the information in section 2) depending on the type of interrupt
controller you have.
- interrupt-parent : the phandle for the interrupt controller that
services interrupts for this device.
- reg : The ID number for the phy, usually a small integer
Optional Properties:
- compatible: Compatible list, may contain
"ethernet-phy-ieee802.3-c22" or "ethernet-phy-ieee802.3-c45" for
PHYs that implement IEEE802.3 clause 22 or IEEE802.3 clause 45
specifications. If neither of these are specified, the default is to
assume clause 22. The compatible list may also contain other
elements.
If the phy's identifier is known then the list may contain an entry
of the form: "ethernet-phy-idAAAA.BBBB" where
AAAA - The value of the 16 bit Phy Identifier 1 register as
4 hex digits. This is the chip vendor OUI bits 3:18
BBBB - The value of the 16 bit Phy Identifier 2 register as
4 hex digits. This is the chip vendor OUI bits 19:24,
followed by 10 bits of a vendor specific ID.
- max-speed: Maximum PHY supported speed (10, 100, 1000...)
Example:
ethernet-phy@0 {
compatible = "ethernet-phy-id0141.0e90", "ethernet-phy-ieee802.3-c22";
interrupt-parent = <40000>;
interrupts = <35 1>;
reg = <0>;
};