b2fe1430d4
In the old times, the whole idle task was considered as an RCU quiescent state. But as RCU became more and more successful overtime, some RCU read side critical section have been added even in the code of some architectures idle tasks, for tracing for example. So nowadays, rcu_idle_enter() and rcu_idle_exit() must be called by the architecture to tell RCU about the part in the idle loop that doesn't make use of rcu read side critical sections, typically the part that puts the CPU in low power mode. This is necessary for RCU to find the quiescent states in idle in order to complete grace periods. Add this missing pair of calls in the h8300's idle loop. Reported-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com> Signed-off-by: Frederic Weisbecker <fweisbec@gmail.com> Cc: Yoshinori Sato <ysato@users.sourceforge.jp> Cc: <stable@vger.kernel.org> # 3.3+ Signed-off-by: Paul E. McKenney <paulmck@linux.vnet.ibm.com> Reviewed-by: Josh Triplett <josh@joshtriplett.org> |
||
|---|---|---|
| .. | ||
| boot | ||
| include/asm | ||
| kernel | ||
| lib | ||
| mm | ||
| platform | ||
| Kconfig | ||
| Kconfig.cpu | ||
| Kconfig.debug | ||
| Kconfig.ide | ||
| Makefile | ||
| README | ||
| defconfig | ||
README
linux-2.6 for H8/300 README
Yoshinori Sato <ysato@users.sourceforge.jp>
* Supported CPU
H8/300H and H8S
* Supported Target
1.simulator of GDB
require patches.
2.AE 3068/AE 3069
more information
MICROTRONIQUE <http://www.microtronique.com/>
Akizuki Denshi Tsusho Ltd. <http://www.akizuki.ne.jp> (Japanese Only)
3.H8MAX
see http://ip-sol.jp/h8max/ (Japanese Only)
4.EDOSK2674
see http://www.eu.renesas.com/products/mpumcu/tool/edk/support/edosk2674.html
http://www.uclinux.org/pub/uClinux/ports/h8/HITACHI-EDOSK2674-HOWTO
http://www.azpower.com/H8-uClinux/
* Toolchain Version
gcc-3.1 or higher and patch
see arch/h8300/tools_patch/README
binutils-2.12 or higher
gdb-5.2 or higher
The environment that can compile a h8300-elf binary is necessary.
* Userland Develop environment
used h8300-elf toolchains.
see http://www.uclinux.org/pub/uClinux/ports/h8/
* A few words of thanks
Porting to H8/300 serieses is support of Information-technology Promotion Agency, Japan.
I thank support.
and All developer/user.