52 строки
1.6 KiB
Plaintext
52 строки
1.6 KiB
Plaintext
Xilinx Slave Serial SPI FPGA Manager
|
|
|
|
Xilinx Spartan-6 and 7 Series FPGAs support a method of loading the
|
|
bitstream over what is referred to as "slave serial" interface.
|
|
The slave serial link is not technically SPI, and might require extra
|
|
circuits in order to play nicely with other SPI slaves on the same bus.
|
|
|
|
See:
|
|
- https://www.xilinx.com/support/documentation/user_guides/ug380.pdf
|
|
- https://www.xilinx.com/support/documentation/user_guides/ug470_7Series_Config.pdf
|
|
- https://www.xilinx.com/support/documentation/application_notes/xapp583-fpga-configuration.pdf
|
|
|
|
Required properties:
|
|
- compatible: should contain "xlnx,fpga-slave-serial"
|
|
- reg: spi chip select of the FPGA
|
|
- prog_b-gpios: config pin (referred to as PROGRAM_B in the manual)
|
|
- done-gpios: config status pin (referred to as DONE in the manual)
|
|
|
|
Optional properties:
|
|
- init-b-gpios: initialization status and configuration error pin
|
|
(referred to as INIT_B in the manual)
|
|
|
|
Example for full FPGA configuration:
|
|
|
|
fpga-region0 {
|
|
compatible = "fpga-region";
|
|
fpga-mgr = <&fpga_mgr_spi>;
|
|
#address-cells = <0x1>;
|
|
#size-cells = <0x1>;
|
|
};
|
|
|
|
spi1: spi@10680 {
|
|
compatible = "marvell,armada-xp-spi", "marvell,orion-spi";
|
|
pinctrl-0 = <&spi0_pins>;
|
|
pinctrl-names = "default";
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
cell-index = <1>;
|
|
interrupts = <92>;
|
|
clocks = <&coreclk 0>;
|
|
|
|
fpga_mgr_spi: fpga-mgr@0 {
|
|
compatible = "xlnx,fpga-slave-serial";
|
|
spi-max-frequency = <60000000>;
|
|
spi-cpha;
|
|
reg = <0>;
|
|
prog_b-gpios = <&gpio0 29 GPIO_ACTIVE_LOW>;
|
|
init-b-gpios = <&gpio0 28 GPIO_ACTIVE_LOW>;
|
|
done-gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
|
|
};
|
|
};
|