/* -*- Mode: C++; tab-width: 2; indent-tabs-mode: nil; c-basic-offset: 2 -*- */ /* ***** BEGIN LICENSE BLOCK ***** * Version: MPL 1.1/GPL 2.0/LGPL 2.1 * * The contents of this file are subject to the Mozilla Public License Version * 1.1 (the "License"); you may not use this file except in compliance with * the License. You may obtain a copy of the License at * http://www.mozilla.org/MPL/ * * Software distributed under the License is distributed on an "AS IS" basis, * WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License * for the specific language governing rights and limitations under the * License. * * The Original Code is mozilla.org code. * * The Initial Developer of the Original Code is * the Mozilla Foundation. * Portions created by the Initial Developer are Copyright (C) 2006 * the Initial Developer. All Rights Reserved. * * Contributor(s): * Josh Lurz * * Alternatively, the contents of this file may be used under the terms of * either of the GNU General Public License Version 2 or later (the "GPL"), * or the GNU Lesser General Public License Version 2.1 or later (the "LGPL"), * in which case the provisions of the GPL or the LGPL are applicable instead * of those above. If you wish to allow use of your version of this file only * under the terms of either the GPL or the LGPL, and not to allow others to * use your version of this file under the terms of the MPL, indicate your * decision by deleting the provisions above and replace them with the notice * and other provisions required by the GPL or the LGPL. If you do not delete * the provisions above, a recipient may use your version of this file under * the terms of any one of the MPL, the GPL or the LGPL. * * ***** END LICENSE BLOCK ***** */ #include "nsISupports.idl" interface nsIDocument; interface nsIDOMRange; interface nsISelection; interface nsIDOMNode; interface nsIOutputStream; [scriptable, uuid(cfc33b4f-6ba0-11da-9531-00e08161165f)] interface nsIDocumentEncoderNodeFixup : nsISupports { /** * Create a fixed up version of a node. This method is called before * each node in a document is about to be persisted. The implementor * may return a new node with fixed up attributes or null. If null is * returned the node should be used as-is. * @param aNode Node to fixup. * @return The resulting fixed up node. */ nsIDOMNode fixupNode(in nsIDOMNode aNode); }; [scriptable, uuid(ea9f3938-6ba0-11da-9531-00e08161165f)] interface nsIDocumentEncoder : nsISupports { // Output methods flag bits. There are a frightening number of these, // because everyone wants something a little bit different /** * Output only the selection (as opposed to the whole document). */ const unsigned long OutputSelectionOnly = (1 << 0); /** Plaintext output: Convert html to plaintext that looks like the html. * Implies wrap (except inside
), since html wraps.
    * HTML output: always do prettyprinting, ignoring existing formatting.
    * (Probably not well tested for HTML output.)
    */
  const unsigned long OutputFormatted     = (1 << 1);

  /** Don't do prettyprinting of HTML.  Don't do any wrapping that's not in
   * the existing HTML source.  This option overrides OutputFormatted if both
   * are set.
   * @note This option does not affect entity conversion.
   */
  const unsigned long OutputRaw           = (1 << 2);

  /** 
   * Do not print html head tags.
   */
  const unsigned long OutputBodyOnly      = (1 << 3);

  /**
   * Wrap even if we're not doing formatted output (e.g. for text fields)
   * XXXbz this doesn't seem to be used by all serializers... document?  How
   * does this interact with
   * OutputFormatted/OutputRaw/OutputWrap/OutputFormatFlowed?
   */
  const unsigned long OutputPreformatted  = (1 << 4);

  /**
   * Output as though the content is preformatted
   * (e.g. maybe it's wrapped in a MOZ_PRE or MOZ_PRE_WRAP style tag)
   * XXXbz this doesn't seem to be used by all serializers... document?  How
   * does this interact with
   * OutputFormatted/OutputRaw/OutputPreformatted/OutputFormatFlowed?
   */
  const unsigned long OutputWrap          = (1 << 5);

  /**
   * Output for format flowed (RFC 2646). This is used when converting
   * to text for mail sending. This differs just slightly
   * but in an important way from normal formatted, and that is that
   * lines are space stuffed. This can't (correctly) be done later.
   * XXXbz this doesn't seem to be used by all serializers... document?  How
   * does this interact with
   * OutputFormatted/OutputRaw/OutputPreformatted/OutputWrap?
   */
  const unsigned long OutputFormatFlowed  = (1 << 6);

  /**
   * Convert links, image src, and script src to absolute URLs when possible
   */
  const unsigned long OutputAbsoluteLinks = (1 << 7);

  /**
   * Attempt to encode entities standardized at W3C (HTML, MathML, etc).
   * This is a catch-all flag for documents with mixed contents. Beware of
   * interoperability issues. See below for other flags which might likely
   * do what you want.
   */
  const unsigned long OutputEncodeW3CEntities = (1 << 8);

  /** 
   * LineBreak processing: if this flag is set than CR line breaks will
   * be written. If neither this nor OutputLFLineBreak is set, then we
   * will use platform line breaks. The combination of the two flags will
   * cause CRLF line breaks to be written.
   */
  const unsigned long OutputCRLineBreak = (1 << 9);

  /** 
   * LineBreak processing: if this flag is set than LF line breaks will
   * be written. If neither this nor OutputCRLineBreak is set, then we
   * will use platform line breaks. The combination of the two flags will
   * cause CRLF line breaks to be written.
   */
  const unsigned long OutputLFLineBreak = (1 << 10);

  /**
   * Output the content of noscript elements (only for serializing
   * to plaintext).
   */
  const unsigned long OutputNoScriptContent = (1 << 11);

  /**
   * Output the content of noframes elements (only for serializing
   * to plaintext).
   */
  const unsigned long OutputNoFramesContent = (1 << 12);

  /**
   * Don't allow any formatting nodes (e.g. 
, ) inside a
.
   * This is used primarily by mail.
   */
  const unsigned long OutputNoFormattingInPre = (1 << 13);

  /**
   * Encode entities when outputting to a string.
   * E.g. If set, we'll output   if clear, we'll output 0xa0.
   * The basic set is just   & < > " for interoperability
   * with older products that don't support α and friends.
   */
  const unsigned long OutputEncodeBasicEntities = (1 << 14);
    
  /**
   * Encode entities when outputting to a string.
   * The Latin1 entity set additionally includes 8bit accented letters
   * between 128 and 255.
   */
  const unsigned long OutputEncodeLatin1Entities = (1 << 15);
  
  /**
   * Encode entities when outputting to a string.
   * The HTML entity set additionally includes accented letters, greek
   * letters, and other special markup symbols as defined in HTML4.
   */
  const unsigned long OutputEncodeHTMLEntities = (1 << 16);

  /**
   * Initialize with a pointer to the document and the mime type.
   * @param aDocument Document to encode.
   * @param aMimeType MimeType to use. May also be set by SetMimeType.
   * @param aFlags Flags to use while encoding. May also be set by SetFlags.
   * XXXjlurz Change nsIDocument to nsIDOMDocument and make this scriptable.
   */
  [noscript] void init(in nsIDocument aDocument, in AString aMimeType, in unsigned long aFlags);

  /**
   *  If the selection is set to a non-null value, then the
   *  selection is used for encoding, otherwise the entire
   *  document is encoded.
   * @param aSelection The selection to encode.
   */
  void setSelection(in nsISelection aSelection);

  /**
   *  If the range is set to a non-null value, then the
   *  range is used for encoding, otherwise the entire
   *  document or selection is encoded.
   * @param aRange The range to encode.
   */
  void setRange(in nsIDOMRange aRange);

  /**
   *  If the node is set to a non-null value, then the
   *  node is used for encoding, otherwise the entire
   *  document or range or selection is encoded.
   * @param aNode The node to encode.
   */
  void setNode(in nsIDOMNode aNode);

  /**
   *  Documents typically have an intrinsic character set,
   *  but if no intrinsic value is found, the platform character set
   *  is used. This function overrides both the intrinisc and platform
   *  charset.
   *  @param aCharset Overrides the both the intrinsic or platform
   *  character set when encoding the document.
   *
   *  Possible result codes: NS_ERROR_NO_CHARSET_CONVERTER
   */
  void setCharset(in ACString aCharset);

  /**
   *  Set a wrap column.  This may have no effect in some types of encoders.
   * @param aWrapColumn Column to which to wrap.
   */
  void setWrapColumn(in unsigned long aWrapColumn);

  /**
   *  The mime type preferred by the encoder.  This piece of api was
   *  added because the copy encoder may need to switch mime types on you
   *  if you ask it to copy html that really represents plaintext content.
   *  Call this AFTER Init() and SetSelection() have both been called.
   */
  readonly attribute AString mimeType;
  
  /**
   *  Encode the document and send the result to the nsIOutputStream.
   *
   *  Possible result codes are the stream errors which might have
   *  been encountered.
   * @param aStream Stream into which to encode.
   */
  void encodeToStream(in nsIOutputStream aStream);

  /**
   * Encode the document into a string.
   *
   * @return The document encoded into a string.
   */
  AString encodeToString();

  /**
   * Encode the document into a string. Stores the extra context information
   * into the two arguments.
   * @param [OUT] aContextString The string where the parent heirarchy
   *              information will be stored.
   * @param [OUT] aInfoString The string where extra context info will
   *              be stored.
   * @return The document encoded as a string.
   * 
   */
  AString encodeToStringWithContext( out AString aContextString,
                                     out AString aInfoString);

  /**
   * Set the fixup object associated with node persistence.
   * @param aFixup The fixup object.
   */
  void setNodeFixup(in nsIDocumentEncoderNodeFixup aFixup);
};