pjs/xpinstall/wizard/windows/builder

***** BEGIN LICENSE BLOCK *****
Version: MPL 1.1/GPL 2.0/LGPL 2.1

The contents of this file are subject to the Mozilla Public License Version 
1.1 (the "License"); you may not use this file except in compliance with 
the License. You may obtain a copy of the License at 
http://www.mozilla.org/MPL/

Software distributed under the License is distributed on an "AS IS" basis,
WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
for the specific language governing rights and limitations under the
License.

The Original Code is Mozilla Communicator client code.

The Initial Developer of the Original Code is 
Netscape Communications Corporation.
Portions created by the Initial Developer are Copyright (C) 1999
the Initial Developer. All Rights Reserved.

Contributor(s):
  Sean Su <ssu@netscape.com>

Alternatively, the contents of this file may be used under the terms of
either the GNU General Public License Version 2 or later (the "GPL"), or
the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
in which case the provisions of the GPL or the LGPL are applicable instead
of those above. If you wish to allow use of your version of this file only
under the terms of either the GPL or the LGPL, and not to allow others to
use your version of this file under the terms of the MPL, indicate your
decision by deleting the provisions above and replace them with the notice
and other provisions required by the GPL or the LGPL. If you do not delete
the provisions above, a recipient may use your version of this file under
the terms of any one of the MPL, the GPL or the LGPL.

***** END LICENSE BLOCK *****

Purpose:
  To build the mozilla self-extracting installer and its corresponding .xpi files
  given a mozilla build on a local system.

Requirements:
1. Perl needs to be installed correctly on the build system because cwd.pm is used.
   Preferably, perl version 5.004 or newer should be used.
   
2. Mozilla\xpinstall\wizard\windows needs to be built.
  a. run nmake -f makefile.win from the above directory


Build.pl requires no parameters.  When it finishes, it will have created a
temporary staging area in mozilla\dist\stage to build the .xpi archives from.
The self-extracting installer (mozilla-win32-installer.exe) will be delivered to:
  mozilla\dist\win32_o.obj\install

The .xpi archives will be delivered to:
  mozilla\dist\win32_o.obj\install\xpi

Mozilla-win32-installer.exe does not require the .xpi archives once its been created
because they have been packaged up in the .exe file.

The .xpi archives will also be copied to:
  mozilla\dist\win32_o.obj\install

This is so setup.exe can install them.  Setup.exe is usually run when debugging the
installer code.  This makes it easier to debug.