m68knommu: make 527x UART platform addressing consistent

If we make all UART addressing consistent across all ColdFire family members
then we will be able to remove the duplicated plaform data and use a single
setup for all.

So modify the ColdFire 527x UART addressing so that:

. UARTs are numbered from 0 up
. use a common name for IRQs used

Signed-off-by: Greg Ungerer <gerg@uclinux.org>

arch/m68k/include/asm/m527xsim.h

@@ -40,6 +40,10 @@
 #define	MCFINT_QSPI		18		/* Interrupt number for QSPI */
 #define	MCFINT_PIT1		36		/* Interrupt number for PIT1 */
 
+#define	MCF_IRQ_UART0	        (MCFINT_VECBASE + MCFINT_UART0)
+#define	MCF_IRQ_UART1	        (MCFINT_VECBASE + MCFINT_UART1)
+#define	MCF_IRQ_UART2	        (MCFINT_VECBASE + MCFINT_UART2)
+
 /*
  *	SDRAM configuration registers.
  */
@@ -72,9 +76,9 @@
 /*
  *	UART module.
  */
-#define MCFUART_BASE1		(MCF_IPSBAR + 0x200)
-#define MCFUART_BASE2		(MCF_IPSBAR + 0x240)
-#define MCFUART_BASE3		(MCF_IPSBAR + 0x280)
+#define MCFUART_BASE0		(MCF_IPSBAR + 0x200)
+#define MCFUART_BASE1		(MCF_IPSBAR + 0x240)
+#define MCFUART_BASE2		(MCF_IPSBAR + 0x280)
 
 /*
  *	FEC ethernet module.

arch/m68k/platform/527x/config.c

@@ -28,16 +28,16 @@
 
 static struct mcf_platform_uart m527x_uart_platform[] = {
 	{
-		.mapbase	= MCFUART_BASE1,
-		.irq		= MCFINT_VECBASE + MCFINT_UART0,
+		.mapbase	= MCFUART_BASE0,
+		.irq		= MCF_IRQ_UART0,
+	},
+	{
+		.mapbase 	= MCFUART_BASE1,
+		.irq		= MCF_IRQ_UART1,
 	},
 	{
 		.mapbase 	= MCFUART_BASE2,
-		.irq		= MCFINT_VECBASE + MCFINT_UART1,
-	},
-	{
-		.mapbase 	= MCFUART_BASE3,
-		.irq		= MCFINT_VECBASE + MCFINT_UART2,
+		.irq		= MCF_IRQ_UART2,
 	},
 	{ },
 };