drivers/thermal/rcar_gen3_thermal: Improve logging during probe
When setting up a new board, a plain "Can't register thermal zone" didn't help me much because the thermal zones in DT were all fine. I just had a sensor entry too much in the parent TSC node. Reword the failure/success messages to contain the sensor number to make it easier to understand which sensor is affected. Example output now: rcar_gen3_thermal e6198000.thermal: Sensor 0: Loaded 1 trip points rcar_gen3_thermal e6198000.thermal: Sensor 1: Loaded 1 trip points rcar_gen3_thermal e6198000.thermal: Sensor 2: Loaded 1 trip points rcar_gen3_thermal e6198000.thermal: Sensor 3: Can't register thermal zone Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com> Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be> Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se> Link: https://lore.kernel.org/r/20220610200500.6727-1-wsa+renesas@sang-engineering.com Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
This commit is contained in:
Родитель
037a6ea0de
Коммит
404dd7dfb1
|
@ -507,7 +507,7 @@ static int rcar_gen3_thermal_probe(struct platform_device *pdev)
|
|||
zone = devm_thermal_zone_of_sensor_register(dev, i, tsc,
|
||||
&rcar_gen3_tz_of_ops);
|
||||
if (IS_ERR(zone)) {
|
||||
dev_err(dev, "Can't register thermal zone\n");
|
||||
dev_err(dev, "Sensor %u: Can't register thermal zone\n", i);
|
||||
ret = PTR_ERR(zone);
|
||||
goto error_unregister;
|
||||
}
|
||||
|
@ -529,7 +529,7 @@ static int rcar_gen3_thermal_probe(struct platform_device *pdev)
|
|||
if (ret < 0)
|
||||
goto error_unregister;
|
||||
|
||||
dev_info(dev, "TSC%u: Loaded %d trip points\n", i, ret);
|
||||
dev_info(dev, "Sensor %u: Loaded %d trip points\n", i, ret);
|
||||
}
|
||||
|
||||
if (!priv->num_tscs) {
|
||||
|
|
Загрузка…
Ссылка в новой задаче