[Blackfin] arch: Enable both edge triggered GPIO IRQs on BF54x and use irq_to_gpio()

Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
This commit is contained in:
Michael Hennerich 2007-12-24 18:51:34 +08:00 коммит произвёл Bryan Wu
Родитель 471b9a6c73
Коммит 8baf560b4c
1 изменённых файлов: 48 добавлений и 23 удалений

Просмотреть файл

@ -483,6 +483,10 @@ static void bfin_demux_gpio_irq(unsigned int intb_irq,
static unsigned char irq2pint_lut[NR_PINTS];
static unsigned char pint2irq_lut[NR_PINT_SYS_IRQS * NR_PINT_BITS];
static unsigned int gpio_both_edge_triggered[NR_PINT_SYS_IRQS];
static unsigned short gpio_enabled[gpio_bank(MAX_BLACKFIN_GPIOS)];
struct pin_int_t {
unsigned int mask_set;
unsigned int mask_clear;
@ -549,13 +553,20 @@ void init_pint_lut(void)
}
static unsigned short gpio_enabled[gpio_bank(MAX_BLACKFIN_GPIOS)];
static void bfin_gpio_ack_irq(unsigned int irq)
{
u8 pint_val = irq2pint_lut[irq - SYS_IRQS];
u32 pintbit = PINT_BIT(pint_val);
u8 bank = PINT_2_BANK(pint_val);
if (unlikely(gpio_both_edge_triggered[bank] & pintbit)) {
if (pint[bank]->invert_set & pintbit)
pint[bank]->invert_clear = pintbit;
else
pint[bank]->invert_set = pintbit;
}
pint[bank]->request = pintbit;
pint[PINT_2_BANK(pint_val)]->request = PINT_BIT(pint_val);
SSYNC();
}
@ -565,6 +576,13 @@ static void bfin_gpio_mask_ack_irq(unsigned int irq)
u32 pintbit = PINT_BIT(pint_val);
u8 bank = PINT_2_BANK(pint_val);
if (unlikely(gpio_both_edge_triggered[bank] & pintbit)) {
if (pint[bank]->invert_set & pintbit)
pint[bank]->invert_clear = pintbit;
else
pint[bank]->invert_set = pintbit;
}
pint[bank]->request = pintbit;
pint[bank]->mask_clear = pintbit;
SSYNC();
@ -593,7 +611,7 @@ static unsigned int bfin_gpio_irq_startup(unsigned int irq)
{
unsigned int ret;
char buf[8];
u16 gpionr = irq - IRQ_PA0;
u16 gpionr = irq_to_gpio(irq);
u8 pint_val = irq2pint_lut[irq - SYS_IRQS];
if (pint_val == IRQ_NOT_AVAIL) {
@ -618,9 +636,11 @@ static unsigned int bfin_gpio_irq_startup(unsigned int irq)
static void bfin_gpio_irq_shutdown(unsigned int irq)
{
u16 gpionr = irq_to_gpio(irq);
bfin_gpio_mask_irq(irq);
gpio_free(irq - IRQ_PA0);
gpio_enabled[gpio_bank(irq - IRQ_PA0)] &= ~gpio_bit(irq - IRQ_PA0);
gpio_free(gpionr);
gpio_enabled[gpio_bank(gpionr)] &= ~gpio_bit(gpionr);
}
static int bfin_gpio_irq_type(unsigned int irq, unsigned int type)
@ -628,7 +648,7 @@ static int bfin_gpio_irq_type(unsigned int irq, unsigned int type)
unsigned int ret;
char buf[8];
u16 gpionr = irq - IRQ_PA0;
u16 gpionr = irq_to_gpio(irq);
u8 pint_val = irq2pint_lut[irq - SYS_IRQS];
u32 pintbit = PINT_BIT(pint_val);
u8 bank = PINT_2_BANK(pint_val);
@ -660,29 +680,34 @@ static int bfin_gpio_irq_type(unsigned int irq, unsigned int type)
gpio_direction_input(gpionr);
if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) {
pint[bank]->edge_set = pintbit;
} else {
pint[bank]->edge_clear = pintbit;
}
if ((type & (IRQ_TYPE_EDGE_FALLING | IRQ_TYPE_LEVEL_LOW)))
pint[bank]->invert_set = pintbit; /* low or falling edge denoted by one */
else
pint[bank]->invert_set = pintbit; /* high or rising edge denoted by zero */
pint[bank]->invert_clear = pintbit; /* high or rising edge denoted by zero */
if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING))
pint[bank]->invert_set = pintbit;
else
pint[bank]->invert_set = pintbit;
if ((type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING))
== (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) {
gpio_both_edge_triggered[bank] |= pintbit;
if (gpio_get_value(gpionr))
pint[bank]->invert_set = pintbit;
else
pint[bank]->invert_clear = pintbit;
} else {
gpio_both_edge_triggered[bank] &= ~pintbit;
}
if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING)) {
pint[bank]->edge_set = pintbit;
set_irq_handler(irq, handle_edge_irq);
} else {
pint[bank]->edge_clear = pintbit;
set_irq_handler(irq, handle_level_irq);
}
SSYNC();
if (type & (IRQ_TYPE_EDGE_RISING | IRQ_TYPE_EDGE_FALLING))
set_irq_handler(irq, handle_edge_irq);
else
set_irq_handler(irq, handle_level_irq);
return 0;
}