Pull media updates from Mauro Carvalho Chehab:
- V4L2 API additions to better support JPEG compression control
- media API additions to properly support MPEG decoders
- V4L2 API additions for image crop/scaling
- a few other V4L2 API DocBook fixes/improvements
- two new DVB frontend drivers: m88rs2000 and rtl2830
- two new DVB drivers: az6007 and rtl28xxu
- a framework for ISA drivers, that removed lots of common code found
at the ISA radio drivers
- a new FM transmitter driver (radio-keene)
- a GPIO-based IR receiver driver
- a new sensor driver: mt9m032
- some new video drivers: adv7183, blackfin, mx2_emmaprp, sii9234_drv,
vs6624
- several new board additions, driver fixes, improvements and cleanups.
* 'v4l_for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/mchehab/linux-media: (295 commits)
[media] update CARDLIST.em28xx
[media] partially reverts changeset fa5527c
[media] stb0899: fix the limits for signal strength values
[media] em28xx: support for 2304:0242 PCTV QuatroStick (510e)
[media] em28xx: support for 2013:0251 PCTV QuatroStick nano (520e)
[media] -EINVAL -> -ENOTTY
[media] gspca - sn9c20x: Cleanup source
[media] gspca - sn9c20x: Simplify register write for capture start/stop
[media] gspca - sn9c20x: Add automatic JPEG compression mechanism
[media] gspca - sn9c20x: Greater delay in case of sensor no response
[media] gspca - sn9c20x: Optimize the code of write sequences
[media] gspca - sn9c20x: Add the JPEG compression quality control
[media] gspca - sn9c20x: Add a delay after Omnivision sensor reset
[media] gspca - sn9c20x: Propagate USB errors to higher level
[media] gspca - sn9c20x: Use the new video control mechanism
[media] gspca - sn9c20x: Fix loss of frame start
[media] gspca - zc3xx: Lack of register 08 value for sensor cs2102k
[media] gspca - ov534_9: Add brightness to OmniVision 5621 sensor
[media] gspca - zc3xx: Add V4L2_CID_JPEG_COMPRESSION_QUALITY control support
[media] pvrusb2: fix 7MHz & 8MHz DVB-T tuner support for HVR1900 rev D1F5
...
tlg2300 release notes
====================
This is a v4l2/dvb device driver for the tlg2300 chip.
current status
==============
video
- support mmap and read().(no overlay)
audio
- The driver will register a ALSA card for the audio input.
vbi
- Works for almost TV norms.
dvb-t
- works for DVB-T
FM
- Works for radio.
---------------------------------------------------------------------------
TESTED APPLICATIONS:
-VLC1.0.4 test the video and dvb. The GUI is friendly to use.
-Mplayer test the video.
-Mplayer test the FM. The mplayer should be compiled with --enable-radio and
--enable-radio-capture.
The command runs as this(The alsa audio registers to card 1):
#mplayer radio://103.7/capture/ -radio adevice=hw=1,0:arate=48000 \
-rawaudio rate=48000:channels=2
---------------------------------------------------------------------------
KNOWN PROBLEMS:
about preemphasis:
You can set the preemphasis for radio by the following command:
#v4l2-ctl -d /dev/radio0 --set-ctrl=pre_emphasis_settings=1
"pre_emphasis_settings=1" means that you select the 50us. If you want
to select the 75us, please use "pre_emphasis_settings=2"
e317234975